Table of Contents
Advertisement
Using
Re @ e
Using Direct Entry
1.
Turn
on
the'
conlpnnent
y()u
_,ant
th_ _ ren_ol_
_ to
op_rate.
2.
Look up the brand and code numb_.r(s) lk_rthe cnmpon_.nt on the cod_. list on page 26.
3.
Press and hold tile component
button that corresponds
to tile component
you want tile
remote to operate
(VCR1, DVD, etc.)
4.
Enl*.r tile code tkom tile code list.
5.
Release tile component
bul/on.
6.
Press ON*OFF to see if tile component
responds
to tile remote commands.
If it doesn't,
try
pressing tile component
buNnn and then ON*OFF again.
7.
If you get no response,
repeat these steps using tile next code listed t_)r your brand until tile
component
responds
to tile remote commands.
The buttons
might
operate
differently
for
other components,
especially when you're
using another
component's
menu
system.
How to Use the Remote After You've
Programmed
It
Once the rem()te has been programmed
successfully,
you are ready tn use it to cnntrnl your
cnmponenls.
To operate
tile component:
1.
Press tile component
button (TV, VCR1, VCR2, DVD, AtX, or SAT*CABLE) lo set tile remnte
to operate tile component.
2.
Press ON-OFF
lo turn tile component
ON or OFF.
3.
Use tile remote bul/ons that apply to that component.
Note: i/'yoz_ keep pressin_,g billions and nothing happens_, the remote i._probab!), in the
u r()_lg lnod_,. Yoz_ mz_slpress the componenl
button thai matches the componenl.gou
want to operate (_.e., (i'yoz_ want to operate hSe VCR, press VCR1 on the remote control to
put the remote in VCR mode<)
25
Advertisement
Table of Contents
