Table of Contents
Advertisement
Using the Remote
Control
Using Direct Entry
1.
Turn
on the
component
you
want
the
remow
to operaw.
2.
Look
up the
brand
and
code
number(s)
[br
the
component
on
the
code
list on page
26.
3.
Press
and
hold
the
component
button
that
corresponds
to the
component
you
want
the
remote
to opmvm.
(VCR1,
DVD,
etc.)
4.
Enwr
the
code
{i'om
the
code
list.
5.
Release
the
component
button.
6.
Press
ON.OFF
to see
ifthe
component
responds
m the
remow
commands.
If it doesn't,
try
pressing
the
component
button
and
then
ON.OFF
agvfin.
7.
If you
get
no response,
repeat
these
steps
using
the
next
code
listed
for your
brand
until
the
component
responds
to the
remote
commands.
rip
The buttons
might
operate differently
for
other components,
especially
when you're
using another
component's
menu
system,
How to Use the Remote After You've
Programmed
It
Once
the remote
has been
programmed
successfully,
you are ready
to use it to control
your
components.
To operate
the component:
1.
Press the component
button
(TV, VCR1, VCR2,
DVD, AUX, or SAT.C&BLE)
m set the
remote
to operate
the component.
2.
Press ON.OFF
to turn
the component
ON or OFE
3.
Use the remote
buttons
that apply
to that component.
Note: l/'you beep pressing bullorts and rlolhirlg happens,
the remole is probabl); in Ihe wrorzg mode.
You mu._l press the compone/nt butlon thai malchea the compone/nt you want to operale (i e., !/you
wahl 1o opovlte the VCR, press VCRI on the r_mole control Io put the remole in VCR mode.)
25
Advertisement
Table of Contents
