Tv + Vcr - RCA F27669TX71AA14 User Manual

C@nnect @ns Setup
TV(back panel)
VIDEO
B L
R AIIOIO L/NOHO _
L
OUT
IL_BLE/
®
S-VIBEO
OtlIIN FROM _ AHT CH3
You need to connect your VCR to your TV From cabl_
or ARteRBa
with audio/video cables in order for Picture-
In-Picture (PIP) to work (see picture above).
Connection: TV + VCR
1. Connect your TV to your VCR
2.
.
A. Connect a coaxial cable to the CABLE/ANTENNA jack on your TV and to the Output Jack on
your VCR (sometimes labeled OfT TO TV).
B. Connect the audio/video cables. Connect audio cables (white and red) to the AtDIO IN jacks
on the back of the TV (R and L/MONO) and to the Audio Output Jacks on the VCR (sometimes
labeled OUT R L).
C. Connect the video cable (yellow) to the VIDEO IN jack on the back ot the TV and to the Video
Output Jack on the VCR.
Connect cable or antenna to your VCR
Connect the coaxial cable fronl your cable
outl_'[,
cable box, or antenna to the Input Jack on your
VCR (sometimes labeled IN FROM ANTENNA or IN FROM ANT).
Connect the G-LINK cable to the TV
A. If you haven't already done so, remove tile Demo Pin from tile G-LINK jack.
B. Connect the G-LINK cable to the G-LINK jack on the TV. Next step, place one of the wands of
the G-LINK cable to work with your VCR (instructions are on p. 13).
Go to page 13
8
Chapter
I