Table of Contents
Advertisement
Re ote
C@ntr@!
Using Direct Entry
k
Turn
on
fl_e
component
you
want
the
remote
lo
operate_
2.
Look up the brand and code number(s)
for the component
on the code list on page 26.
3.
Press and hold the component
button that corresponds
lo the component
you want tile
remow to operaw
(VCR1, etc.)
4.
Enter the code from file code list.
5.
Release the component
buuon.
6.
Press ON*OFF to see if the component
responds
to the remow commands.
If it doesn't, try
pressing tile component
bunon and then ON*OFF again.
7.
If you get no response,
repeat these steps using tile next code listed for your brand until tile
component
responds
to tile remote commands.
rip
The buttons might
operate differently for
other components,
especially when you're
using another
component's menu
system.
How to Use the Remote After You've
Programmed
It
Once
the remole
has been
programmed
successl\llly,
you are ready
to use it lo control
your
components.
To
operaw
the component:
1.
Press the component
bullon
(TV, VCR1, VCR2, DVD, A[X,
or SAT*CABLE)
R> set tile remote
to
operate
the component.
2.
Press ON-OFF
to turn tile component
ON or OFF.
3.
[se
tile remote
buuons
that
apply
to that component.
Note: If you keep pressing buttons and nothing happens, the remote is probably in the wrong mode. You
must pressthe component button that matches the component you want to operate (i.e, if you want to
operate the VCR, pressVCR1on the remote control to put the remote in VCR mode)
Chapter
2
25
Advertisement
Table of Contents
