RCA F27669TX71AA14 User Manual page 20

C@nnect @ns Setu@
ii i!iiiliiiiiiiii iiiiiii!ii}iHiii
iiiiiii_i,}i,li,i,i,i,l,iN_i_iiiiiiiiiii_i_
Step 3: Configuring for a VCR
1. If your TV is cnnnect_d to a VCR, press OK.
If it is not, highlight No and press OK (a screen will appear reminding you
to connect your G-LINK cable to your TV and VCR.).
2. [se the up and down arrow buttons to highlight tile brand of your VCR that
is connected to the TV and press OK.
If your brand isn't listed, highlight Not Listed and press OK.
3_
Tune your VCR to channel 02. Next, turn OFF your VCR. When you
complete these steps, press OK to begin testing.
Important Note: Whe*_ code testing i._in progress, don't toJ_ch yoJ_r 7'I_
VCR, or an)' of the remote controtsjbr tbese products.
4_
Look at the l_()nt of your VCR. If your VCR turned on automatically and
changed to channel 09, tile test was successful. Highlight Yes and
press OK.
If your VCR didn't change to channel 09, you can either choose No or 7},st
this cocl_, ct/dai_t.
If you think your TV or remntes might have been touched during tile test,
tune your VCR to channel 02, turn off your VCR and highlight 7?,st tbLs
code again.
If you don't think the test was interrupted, highlight No. Tune your VCR to
channel 02 and turn off your VCR. Press OK (the GUIDE Plus+ system starts
testing another set of codes.)
Keep tk_llowing tile previous instructions until the VCR finds the
correct code.
18 Chapter I