Programming The Remote To Operate Other Components; Find Out If You Need To Program The Remote; How To Program The Remote - RCA F27669TX71AA14 User Manual

Using Re te C@ntr@!
You'll use these buttons when you program the
remote to operate another component.
The remote may not operate all models of
all brands.
Programming the Remote to Operate
Other Components
"File universal renlote control can be prngranlmed to operate lllost brands
of remote cnntrnllable VCRs, satellite receivers and cable boxes. "File
remote is already programmed to operate most RCA, GE and PROSCAN
TVs, VCRs, DVD players, laserdisc players and satellile receivers.
Find Out If You Need to Program the Remote
To determine whether the universal remote needs to be programmed,
turn a component ON, such as a VCR, point the remote at the VCR, and
press the VCR1 button. Then press ON *OFF or channel tip or channel
down to see it the VCR responds to the remote commands. If not, the
r(,niot(, ne('ds tn be progranlnlt, d.
How to Program the Remote
There
ar(* two ways t() pr()graln
tile remote control:
automatic cod(*
search and direct entry. Instructions t_)r both ways fi)llow.
To stop the automatic code search without
programming any components, press and hold CLEAR
until the light on the remote turns off.
Using Automatic Code Search
1. Turn on tile component you want tile remote to operate (VCR, DVD
Player, etc.)
2_
Press and hold the conlpnnent button on the renlnte cnntrnl that
corresponds to the component you want tile remote to operate
(VCR1, DVD, etc.). While you hold down tile component button,
press and hold ON°OFF (wl_en tile red light on tile remote turns
on, release both buttons).
3. Press PLAY (the red light on the remote, located belnv,_ tile ON,,OFF
button, starts flashing).
The remote is searching tile first set of component codes (there are
20 sets of codes). If the component you *_.ant to operal_, doesn't
turn off automatically afler 5 seconds, press PLAY again (the red
light starts flashing again as the remote searches through the next
set of codes).
Continue pressing PLAY until the component turns off.
4_
Note: I/'the component doesn't turn (ffff'c(fleryoz_'_,epress(,d the
IoIAY bz_tto_ 20 time._, tlne component can't be programmed.
Press REVERSE, wait 2 secnnds. Repeat this sl(.p until the
component turns back on.
5. "lb finish, press and hold the STOP button until the red light on the
remote turns off.
24