Care And Cleaning - RCA F27669TX71AA14 User Manual

The Remote Control Doesn't Work
Something might be between the remote and the remote sensor on the component. Make sure there is a clear path.
Maybe the remote isn't aimed directly at the component (TV or VCR) that you're t_ing to operate.
Maybe remo_ is not ill TV Mode. ¸Press file TV button so remote will control T_
Maybe batteries ill remote are weak, dead or installed incorrectly. Put new batteries in the remote. (Note, if you remove the
batteries, you may have to reprogram the remote to operate other components.)
You might need to drain the remote's microprocessor: remove batteries and press the number 1 button _r at Ieast 6() seconds.
Release file 1 button, replace file batteries, and (if necessary) program the remote again.
PIP (Picture-In-Picture Feature) Doesn't Work
The PIP feature on tills TV only works if" you connect a sucond video source (liku a VCR or satullite rec_,iver) to your TV with audio/
video cables. If you use a cable box you may need extra equipment. Contact your cable company and/or go to page 12 fk)r more
details about a cable box connection.
Make sure the remote is in the right mode. For example, once you turn on file VCR with the VCR1 button, you can't S_5\P the
pictures until you put the remote in TV mode. Just press file TV button.
No signal or bad reception? Most VCRs and satellite, receivers have an antenna or FV button. If your cable or offair antenna goes into
your VCR or satellite receiver, then into your ['V t W pressing the antenna or TV/VCI,: button on tile front of tile
component.
Tip: If programmed to control your VCR, the ANTENNA button on file remote acts as a TV/VCR button.
Problems with V-Chip/Parental Controls
The rating limits don't work
You must lock the settings. Go to the 7'/'MA/A:,*/II£\'_ (press MENU on your remote) s_qect Pare_ital (Jontrols (press 6 on your
remote), select Lock t,artmtal Cbntrols (press 6 on your remote).
I don't remember my password and I want to unlock the TV
If you forgut your password, simultan_,ously press and hold MENI on thu television and volume down on thu remote f_)r 3 seconds.
Nothing appears on the screen, Parental Controls simply unlock and you can re enter a password via Lock Parental ControL_.
The V=Chip won't let me watch a program even though it's not rated as violent.
Maybe the movie' was given an NR (Not Rated) status. After you block movie ratings, you must set XR to View s_,parately in ord_'r to
vk'w movies with an NI,' rating.
Care and Cleaning
CAUTION: Turn OFF your TV before cleaning.
You can clean the TV as required, using a soft linl-tkee cloth. Be sure to occasionally dust the ventilation slots in the cabinet
to help assure adequate ventilation.
The TV's screen may be cleaned with a soft, lint-free cloth as well. Take care not to scratch or mar the screen. If
necessary, you may use a cloth dampened with warm water.
Never use strong cleaning agents, such as ammonia-based cleaners, or abrasive powder. These types of cleaners
will damage the TV.
While cleaning do not spray liquid directly on the screen, or allow liquid to run down the screen and inside the TV. Also,
avoid placing drinks or wtses with water on top of the TV. This could increase the risk of fire or shock hazard or damage to
the TV.
Caution: If fixed (non-moving) images are letk on the screen t_>rlong periods, they may be permanently imprinted on the
picture robe. Such images include network logos, phone numbers, and vide<>games. This damage is not covered by your
warran/y. Extended viewing of channels displaying these images should be avoided.
56 Chapter 5