Edimax EW-7428HCn User Manual page 50

Passphrase Key
Device
Configuration
Config Mode
Configure via
Push Button
Input Client PIN
Code
Note: When using PBC-type WPS setup, you must
press the hardware or software WPS button on the
wireless client within 120 seconds. If you do not do
so in time, you will need to activate WPS on this
access point again.
Shows the WPA passphrase here, though all
characters will be replaced by asterisks for
security reasons. If encryption is not set on
this access point, this field will be blank.
Configuration options for the device's WPS
settings can be found here.
There are "Registrar" and "Enrollee" modes
for the WPS connection. When "Registrar"
is enabled, the wireless clients will follow
the access point's wireless settings for WPS
connections. When "Enrollee" mode is
enabled, the access point will follow the
wireless settings of wireless client for WPS
connections.
Click "Start PBC" to start Push-Button style
WPS setup. This access point will wait for
WPS requests from wireless clients for 2
minutes. The "WLAN" LED on the access
point will stay on for 2 minutes while this
access point waits for incoming WPS
requests.
Please input the PIN code of the wireless
client you wish to connect, and click the
"Start PIN" button. The "WLAN" LED on the
access point will stay on while this access
point waits for incoming WPS requests.
50