Edimax EW-7428HCn User Manual page 44

MAIN SSID
Multiple ESSID
AP Isolation
SSID Isolation
Channel
Number
Associated
Clients
Root AP SSID
If you select 2.4GHz (B+G), then only
devices using the 802.11b and 802.11g
bands will be able to connect to this device.
If you want to allow 802.11b, 802.11g, and
802.11n devices to connect to this device,
select 2.4GHz (B+G+N).
Please input the ESSID (the name used to
identify this wireless access point) here. You
can input up to 32 alphanumerical
characters. Please note that the ESSID is
case sensitive.
When you press this button, a new window
will appear, allowing you to assign up to
four ESSIDs to this access point. Please see
the following page for more details.
When this is set to "Enabled", wireless
clients connected to this device will be able
to access the Internet, but will not be able
to communicate with each other. This
applies to clients connected to the MAIN
ESSID only.
When the access point uses multiple SSIDs
and this is set to "Enabled", then wireless
clients connected to the same SSID will be
able to communicate with each other, but
will not be able to communicate with other
wireless clients connected to another of this
access point's SSIDs. You can input a
numeric VLAN ID value between 1 – 4094
for the MAIN ESSID.
Please select a channel number you wish to
use. The channel number must be same as
the other wireless access points you wish to
connect to.
Click the "Show Active Clients" button and a
new window will appear, which contains
information about all wireless clients
connected to this access point. You can click
the "Refresh" button in the popup window
to keep the information up-to-date.
In Universal Repeater mode, this device will
44