Whirlpool SF387PEY Use And Care Manual page 21

5. Push
the Start/Enter pad. "Lo °'', HEAT,
TIMED, and BAKE will light up on the
display to indicate that the oven is
heating.
NOTE: The display will show "door" and a
tone will sound once a minute for 5 min-
utes if the door is latched when you try to
bake/roast.
You can change the temperature or
time settings any time after pushing the
Start/Enter pad by repeating any of Steps
2 through 4.
6. The display will count down the baking/
roasting time in minutes.
7. When the baking/roasting time is
completed, the oven will turn off auto-
matically, four tones will sound, and "End"
will show on the display. You will also
hear four 1-second tones every minute
until you push the Off/Cancel pad.
NOTE: To disable reminder tones, push
and hold the Cook Time pad for 4 sec-
onds. To reactivate tones, repeat this
procedure.
To cancel the MEALTIMER'" control
setting:
• Push the Off/Cancel pad to return the
display to the time of day.
To delay start and stop
automatically
Method 1-Using Cook Time
and Delay Start Time:
1. Position the oven rack(s) properly and
put food in the oven.
2. Push the Bake pad to enter the Bake
mode. Use the Temp pad(s) to set the
desired temperature. Push • to raise the
temperature or • to lower the tempera-
ture in 5°F increments. Use these pads
until the desired temperature shows on
the small display.
After you have set the desired tem-
perature, the display will show the set
temperature and the time of day. BAKE
will light up.
I=ILM'J
continued on next page
21