Download Print this page
Whirlpool GS445LEMS1 Installation Instructions Manual
Whirlpool GS445LEMS1 Installation Instructions Manual

Whirlpool GS445LEMS1 Installation Instructions Manual

30" freestanding sealed burner gas range with self-cleaning oven

Advertisement

Quick Links

m
m
Burner
with self-cleaning oven
Tip Over
Hazard
A child or adult
can tip the range
and
be killed.
Connect
anti-tip
bracket
to rear
range
foot.
Reconnect
the anti-tip
bracket,
if the
range
is moved.
Failure
to follow
these
instructions
can
result
in death
or serious
burns
to
children
and adu[ts.
Reference
Table of Contents:
Pages
[]
[]
[]
[]
[]
[]-%
[]
[]
[]
9758659
Before you start
Electrical requirements
Gas supply requirements
Product dimensions
Cabinet dimensions/requkements
Installation steps
Gas conversions
if range does not operate
if you need assistance/service
Moving the range
www.whM
pooH.corn
Read and save these instructions.
iMPORTANT:
installer:
Leave
installation
hstructions
with
the
homeowner.
Homeowner:
Keep
Installation
Instructions
for future
reference,
Read and save these
instructions
for local
electrical
inspector's
use.
Write
down
the model
and serial
numbers
before
installing
range.
Both
numbers
are listed
on the
model/serial
rating
plate
located
on the
oven
frame
behind
the storage
drawer
panel.
Model
#
Serial
#
Part No. 9758659

Advertisement

loading

Summary of Contents for Whirlpool GS445LEMS1

  • Page 1 9758659 Burner with self-cleaning oven Reference Table of Contents: Pages Before you start Electrical requirements Gas supply requirements Product dimensions Tip Over Hazard A child or adult can tip the range Cabinet dimensions/requkements be killed. []-% Installation steps Connect anti-tip bracket to rear range...
  • Page 2 Before you start... It is the customer's responsibility: Your safety and the safety WARNING: ff the • To contact a qualified electrical installer. others are very important. information in this manua_ • To assure that the electrical installation We have provided many important safety is not fommowed exactRy,...
  • Page 3 Tools needed: Materials needed: Parts supplied: Assemble the required tools and parts • gas line shutoff valve before starting installation. Read and • 1/2" male pipe thread nipple for connection Not shown: follow the instructions provided with to pressure regulator •...
  • Page 4 Gas supply requirements Observe aii governing codes and ordinances. connection: Rigidpipe This installation must conform with local Requires codes and ordinances, in the absence combination pipe fittings local codes, installations must conform with American National Standard, obtain an in-line connection to the range.
  • Page 5 Product dimensions Grounded electrical oudet is required+ See "Electrical requirements/' Proper gas supply connection must avaHaNe+ See "Gas supply requirements:" 27-1/8" (68.9 cm) depth with handle (91.4 cm) cooktop height 46-7/8" (!19+1 cm) overall height 25" (63+5 cm) 29-7/8" (75+9 cm) width Cabinet dimensions/requirements iMPORTANT: Some...
  • Page 6 New start... Contact a qualified floor covering installer for the best procedure Make sure the anti-tip bracket is drilling mounting holes through your installed: type floor covering. Excessive Weight Hazard • Look for the anti-tip bracket securely attached to floor. Use two or more people to move...
  • Page 7 Gas and electrical connections Use 5/16" combination wrench [] Appiy pipe-joint compound made [] Test all connections for use with LR gas to the smaller thread and channel lock pliers to attach brushing on an approved non-corrosive ends of the flexiMe connector adapters.
  • Page 8 Check operation if flame needs to be adjusted, turn You can check the burner flame Electronic ignition system control knob to the "LOW" setting removing the flame spreader or by using Cooktop and oven burners use eiectronic remove control knob. Insert a small flat-...
  • Page 9 [f your oven has electronic If oven flame needs to be adjusted: If your oven has electronic Locate the air shutter next to the controJs: controls: pressure regulator. Loosen screw 1. Press the "BAKE" pad. 1. Press the "CUSTOM BROIL' pad. adjust the air shutter until...
  • Page 10 GEts convet'sions L.R Gas Gas conversions (from Naturai gas to LR pressure regulator.. gas; or from LR gas to Naturai gas) must Color Surface Propane rate Orifice be done by a quaiified installer, burner (BTU/hr) Number Marking Green/ Left 8,000 rear Lt.
  • Page 11 Reinstall the storage drawer, [] Surface burners: Remove burner Oven burner: 1/2" combination CompJete installation steps 9 through caps. Use a Phillips or Quadrex wrench to loosen the orifice hood away Checking for proper cooktop burner screwdriver to remove the two screws from (approximately...
  • Page 12 If range does not If you need assistance: If you need service: operate: if you have questions about operating, Maintain the quality built into your range cleaning or maintaining your range: by calling an authorized service Check that the circuit breaker is not compan%...