Advertisement
] A WARNING
. ALL RANGES CAN
TIP
. INJURY TO PERSONS
COULD RESULT
. INSTALL ANTI-TIP
DEVICE PACKED
WITH RANGE
. SEE INSTALLATION
INSTRUCTIONS
IMPORTANT:
Read and save
these instructions.
IMPORTANT:
IIlStdkr:
Leave Installation
Instructions
with
the homeowner.
Homeowner:
Keep Installation
Instructions
Part No. 36-3 14445-02-O/4363404
30" Freestanding
Sealed Burner
m
Range
for future reference.
Save
Installation
Instructions
for local
electrical
inspector's
use.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Whirlpool SF388PEWN0
Summary of Contents for Whirlpool SF388PEWN0
- Page 1 ] A WARNING . ALL RANGES CAN . INJURY TO PERSONS COULD RESULT . INSTALL ANTI-TIP DEVICE PACKED WITH RANGE . SEE INSTALLATION INSTRUCTIONS IMPORTANT: Read and save these instructions. IMPORTANT: IIlStdkr: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference.
-
Page 2: What To Do If You Smell Gas
Before you start... Proper installation; your responsibility. A qualified technician should install this range. Make sure you have everything necessary for correct installation. the responsibility of the installer to comply with the installation clearances specified on the serial/rating plate. The serial/rating plate is located on the oven... -
Page 3: Tools Needed For Installation
Tools needed for installation: hand or electric drill concrete/ceramic floors: Q/16” masonry drill bit wood floors: 3/32” drill bit gas line shutoff valve L.P.-resistant pipe-joint compound A.G.A. design-certified flexible metal connector (A-5 feet) wrench ‘V Gas supply requirements Observe all governing codes and ordinances. - Page 4 Now start... With range in kitchen. w Remove racks and other parts from inside oven. W Place one foot on the shipping base. Tilt range forward slightly to free rear legs. Gently lower range to floor. Tilt range backwards until legs are free.
- Page 5 Numbers correspond to steps. 14. 15. 16. 17. Product Damage Carefully place burner cap over electrode. Failure to do so may damage electrode. _ burner Place the burner cap over locating tabs on burner base. Burner cap should be level when properly positioned Place burner grates over burner and caps.
-
Page 6: Natural Gas Conversion
L.P. gas conversion Converting to L.P. gas should be done by a qualified installer. Fire Hazard . Locate gas supply valve between pressure regulator and gas valve. Shut off gas supply valve to range before converting to L.P. gas. Make all cooktop, oven and broil burner conversions before turning gas supply valve back on. - Page 7 If you need servfce... In the event that your Whirlpool could should need service, call the dealer whom you purchased the appliance Whirlpool-authorized service...
Need help?
Do you have a question about the SF388PEWN0 and is the answer not in the manual?
Questions and answers