Changing The Signal Type; Adding Or Removing Channels - ProScan PSVR87 User Manual

AUTO CHANNEL SEARCH
Now scanning channel 14
Press any key to cancel
The VCR begins scanning for the available channels--this
takes about one to two minutes. When the scan is complete,
the VCR tunes to the lowest channel number available. At
this point, pressing CHAN + or - on the remote should only
select active channels.
CHANGING THE SIGNAL TYPE
This feature is useful if your cable signal goes out; it allows you
to switch to a regular antenna for alternate television reception.
1. Press MENU to display the VCR MAIN MENU.
2. Press 4 to display the CHANNELS menu.
CHANNELS
I Auto _hannel Search
2 Add/Remove Channels
A VCR Plus+ Channel
List
5 Cable Box Setup
6 SAT Setup
0 Exit
3. Press 3 to change the Signal Type between Cable and
Antenna. When you are finished, press 0 to exit back to the
Main Menu and 0 again to exit to normal viewing.
ADDING OR REMOVING CHANNELS
You may want to add or remove channels after you auto
channel search, especially if channels have weak signals or
content you don't want to watch. To achieve this:
1. Press MENU to display theVCR MAIN MENU
2. Press 4 to display the CHANNELS menu
3. Press 2 to display the ADD/REMOVE CHANNELS screen.
Use the CHANNEL + or- buttons on the remote or enter a
specific channel number with the number buttons to go to
the channel you want to add or remove.
Selecting Channels
The CHANNEL + and - buttons
access those channels which are
active in yourVCR channel list.
You can still access channels not in
the channel list by using the
number buttons on the remote.
13