Table of Contents
Advertisement
PROG RAMMING
TH E REMOTE
TO CONTROL
A
LASER DISC PLAYER OR DVD
COMPONENT
The VCR2-DVD button on the remote is programmed
to control
a VCR set to respond to the VCR2 button
or an RCA, ProScan, or
GE laser disc player.
If you have an RCA DVD component,
you can program
the
VCR2.DVD button to operate
it.
1.
Turn on the component.
2.
Look up your component
and its code number in the code
list on the right.
3.
Press and hold the VCR2.DVD button
on the remote.
4.
Enter the three-digit
code from the code list.
5.
Release the VCR2-DVD button,
and press PWR. If the
component
turns off, setup is complete.
OPERATE
THE
COMPONENT
After you have set up your remote, see which buttons will
operate
it.
1.
Point
the remote
at the component,
and press VCR2°DVD.
If it does not turn
on, press VCR2oDVD
and then
PWR.
2.
You may want to experiment
to see which buttons will
operate your component.
Try pressing buttons, such as CHAN
up or down.
RCA, ProScan,
and GE Codes
VCR
........................................................
037
LaserDisc
Player ...................................
037
DVD
......................................................
078
I
his remote
ma.y not
operate
all
1
models
of the
brands
that
are shown.
4O
Advertisement
Table of Contents
