Download Print this page
Pioneer CT-W616DR Operating Instructions Manual

Pioneer CT-W616DR Operating Instructions Manual

Stereo double cassette deck
Hide thumbs Also See for CT-W616DR:

Advertisement

STEREO
DOUBLE
CASSETTE
DECK
CT-W606DR
CT-W616DR
__:l_h=.__
]_!
:,=
J_
r'=_-_--_
[I
- I.I
- IOl . I'1
-
@
_t
The above illustration shows CT-W616DR.
About the Demo mode (*)
Press the Deck II counter
reset button
(RESET) and the DECK II time
counter
button (TIME/COUNT)
simultaneously
to set the demonstration
mode. To cancel the demonstration
mode, press any one of the buttons en-
closed in the dotted lines above.
Thank you for buying this Pioneer product.
Please read through these operating instructions
so you will
know how to operate your unit properly. After you have fin-
ished reading the instructions, keep them in a safe place for
future reference.
In some countries
or regions, the shap.._,_df t he power plug
and power outlet may sometimes
differ from that shown in
the explanatory drawings. However, the method of connect-
ing and operating the unit is the same.
WARNING:
TO PREVENT RRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOIS-
TURE.
IMPORTANT
NOTICE
[For U.S. model]
The serial number for this equipment
is located on the rear
panel, Please write this serial number on your enclosed war-
rarity card and keep it in a secure area. This is for your security.
CAUTION
This product satisfies
FCC regulations
when shielded
cables and connectors
are usedlo
connect
the unit to
other equipment, To prevent electromagnetic
interference
with electric appliances
such as radios and televisions,
use shielded cables and connectors for connections.
This product complies with the Low Voltage Directive (73/23/
EEC),EMC Directives (89/336/EEC,92/31/EEC)and CE Marking
Directive (93/68/EEC).
THE POWER SWITCH IS SECONDARY
CONNECTED
AND THEREFORE
DOES NOT SEPARATE THE UNIT
FROM MAINS POWER IN STANDBY POSITION.
IMPORTANT
1
The
lightning
flash
with
arrowhead,
within
an
edui_teral
triangle, is intended
to alert the user to the
t0_esence of unin_Jlat ed "dangerous _oltage" within the
product's
enclosure
that
may
be of sufficient
magnitude
to constitute
a risk of electric
shock to
_l'$orts.
CAUTION:
TO PREVENT
THE RISK OF ELECTRIC
SHOCK,
DO
NOT REMOVE
COVER
(OR SACK).
NO USER-SER-
VICEABLE
PARTS
INSIDE.
REFER SERVICING
TO
QUAUFIED
SERVICE PERSONNEL
The exclamation
point within an equilateral triangle
is
intended to alert the user to the presence of important
opQrating and malnten_nce
(servicing) instructions
in
the liteceture accompanying
the appliance
PlONEF_R"
The Art of_

Advertisement

loading

Summary of Contents for Pioneer CT-W616DR

  • Page 1 FROM MAINS POWER IN STANDBY POSITION. The serial number for this equipment is located on the rear panel, Please write this serial number on your enclosed war- rarity card and keep it in a secure area. This is for your security. IMPORTANT lightning flash...
  • Page 2 When this unitisbroughtintoa warm room from previously c oldsurroundings orwhen the room temperaturerises sharply, c ondensation may form inside, a nd theunitmay not be ableto attain i ts full performance. To preventthis, allowthe unit tostand for about an hour beforeswitch- ingit on, or raise the room temperature gradua y.
  • Page 3 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 4 Sensor holes TYPE IV (Metal) tape TYPE 11 (High/CrO2) tape Because over the C-90 tapes are very thin, they can easily jam in the pinch rollers and capstan, and they often are subject to other problems I D_o ertheng0minutesinlen such as rregu ar winding,...
  • Page 5: Table Of Contents

    POWER-CORD CAUTION Handle the power cord by the plug. Do not pull out the plug by tug- I CONTENTS ging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock, Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the...
  • Page 6: Connections

    Red plug Intermediary jack which outputs signals from the CONTROL IN jack of this unit to the input jack of another unit. Connect this jack to the CONTROL IN jack of another component compatible with PIONEER Connect the TAPE jacks of your amplifier to the LINE jacks of the System Remote Control.
  • Page 7: Front Panel Facilities

    Even when the switch is in the STANDBY position, there will be : Forward playback _MI/MS : Fast reverse/music search a power flow to the deck's circuits as long as the power cord is connected to a power outlet. iMp/MS : Fast forward/music...
  • Page 8 (As s result, the noise in the middle of music is equivalent to the The FLEX system is designed to improve high frequency...
  • Page 9 Both sides of a tape are played back repeatedly using the auto re- ing and maintains it at the optimal level based on the amount of the verse system. When 16 sides of the tape have been played back the...
  • Page 10: Playback

    With the power off, press and hold the stop (m) but- ton of DECK l, and turn the power on. Continue to hold the stop (1) button for approximately five seconds. DECK ] can now be operated using the remote control unit, but DECK ]l cannot.
  • Page 11: Single Playback

    (RESET) TWO MODES COUNTER Press this button to reset the tape counter to 0 o _ 0, or to reset the time counter to u n 0:0 0. Counter Mode button (TIME/COUNT) Press the button, and 2 modes change alternately.
  • Page 12: Relay Playback

    2. Select the Dolby NR mode with the DOLBY NR button. It can find a selection located up to 15 selections before or after the • Always set the switch to the same positions that were used present position.
  • Page 13: Recording

    2. If you use AUTO BLE XD, press BLE XO button. (Ex- • If the old tape, the tape end or the leader (white portion) immedi- cept for U.S. model of CT-W606DRI ately prior to the tape end is reached during AUTO BLE XD opera- 3, Select the Dolby NR mode with the DOLBY NR button.
  • Page 14 PIONEER ELECTRONICS OF CANADA, INC. 300 AltstateParkway.Markham, OntarioL3R 0P2, Canada PIOI_EER ELECTRONIC(EUROPIE] N.V. Haven 1087. Keetberglaan1. 9120 Melsele. BelgiurnTEL:03/570.05.11 PIONEER ELECTRONICS AUSTRALIA PTY. LTD. 178-184 Boundar/Road. Braeside.Victoria3195. Australia.TEL:{03] 95866300 PIONEER ELECTRONICS DE MEXICO S.A. DE C.V. SanLorenzoNumlOO93erplsoDesp. 302CoI. DelValle. MexicoD.F, C P. 03100 TEL:5-688-52_0 <96K00ZYOP00>...

This manual is also suitable for:

Ct-w606dr