Maytag 23-11-2198N-005 User Manual page 4

Installation°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°
Window Dstal don
4. Keeping a firm grip on air conditioner, carefully center
air conditioner in window opening with the bottom
bar between the window stool and the angle bracket.
Air conditioner should slant slightly downward on the
outside as shown by half a bubble off on a carpenters
level. This outward pitch prevents water from entering
the room (Fig. I).
6. Secure top of filler panels by driving 5/8" long wood
screws into window sash through mounting holes in
top slides.
7. Secure bottom of filler panels by driving S/8" long
screws into window sill through filler panel tabs.
8. Cut foam seal to width of window and install between
upper and lower window sash (Fig. J).
Installation in window
19" to 22" wide
(Do not attach filler panels for this application)
1. Refer to steps 1 and 2 of preceding instructions.
2. Close window until it touches behind top bar
(Fig. J).
3. Fasten
lower window sash to window frame using fin-
ishing nails, wood screws, or "L" brackets (Fig. K).
Bottom
Filh, r
Panel
Track
Fillet' Board
(Optional)
SIDE _qEW
5. Close the window until it touches behind air condi-
tioner top bar. Slide filler panels outward until they
touch window sash tracks. (Do not release grip on air
conditioner until lower window sash is in final posi-
tion) (Fig. J).
Lower
!ATitldow
Sash
5/8" Wood Screw
I 5/,_"
Wood Screws
Ffgo K
Nails/
L-Bracket
4. If filler is required on sides of air conditioner, cut foam
seal to size and fill both sides.
5. Cut foam seal to width of window and install between
upper and lower window sash {Fig. J).
Caution: Do not drill a hole in bottom pan. Unit is
designed to operate with approximately 1/2" of water in
bottom pan.
!4{md ,Sill Filler Panel INSIDE VIEW
3