Mitsubishi VS-5075 Owner's Manual page 40

Projection TV + audio system
equipment you will need
To hook-up an audio system, you
will need:
• one set of RCA pin-type audio
cables.
procedure
O Connect audio cables to the AUDIO MONITOR OUTPUT
terminals on the Projection TV. Use the red cable to connect
the right channel and the white one to connect the left channel.
O Connect the other ends of these cables to the AUX IN terminals
on the back of the audio system.
O
Turn off the Projection TV's speakers. To do this, press the
AUDIO button on the control panel or the remote until you see
the "Speaker:" display. Press the ADJUST buttons to set the
setting to "External." See "Adjusting the sound," pages 70 - 71.
Set the audio system's input to the AUX position.
[---- White Lead
[_-- Red Lead
@
Audio :System Rear Terminals
AUX
-'_ L (_
---.--_ R _)
White Lead
Red Lead
@
Projection TV Rear Terminals
VIDEO l AUDIO I
You should make this connection in addition to one of the other
connections in this chapter, not instead of other connections.
40 Chapter 2: Connecting Your Projection TV