Mitsubishi VS-5075 Owner's Manual page 29

Projection TV + cable with a cable box
equipment you will need
Use this hook-up if you need a cable box to descramble some of your
cable signals. When you complete this hook-up, you should set up
your remote control to operate your cable box (see page 48).
To complete the hook-up, you will need:
one two-way splitter, and
IN
OUT OUT
three 75 ohm coaxial cables.
procedure
(Please see illustration on the following page.)
O Connect your cable system's incoming cable to the IN terminal
on the two-way splitter.
O Connect a coaxial cable to one of the OUT terminals on the
splitter; connect the other end of this cable to the ANT-A
terminal on the back of the Projectio:a TV.
Connect the second coaxial cable t_ the second OUT terminal
on the splitter; connect the other end of this cable to the IN
terminal on the cable box.
Connect the third coaxial cable to the OUT terminal on the
back of the cable box; connect the other end of this cable to the
ANT-B terminal on the back of the F_ojection TV.
Basic Connections 29