Mitsubishi VS-5075 Owner's Manual page 33

Important:
Important:
procedure
(Please see illustration on tlhe following page.)
O Connect the incoming cable or antenna to the ANTENNA IN
terminal on the VCR.
O Connect one end of a coaxial cable to the ANTENNA OUT
terminal on the VCR.
Connect the other end of the coaxial cable to the ANT-A
terminal on the Projection TV.
0 Do ONE (not both) of the following:
Connect a video cable to the VIDEO OUT terminal ,on
the back of the VCR. Connect the other end of this cable to
one of the VIDEO INPUT terminals or_ the back of the
Projection TV.
Connect an S-video cable to the S-VIDEO OUT terminal
on the VCR. Connect the other end of this cable to one
of the S-VIDEO INPUT terminals on the back of the
Projection TV.
Connect audio cables to the AUDIO OUT terminals on the back
of the VCR. Use the red cable to connect the right (R) channel
and the white cable to connect the left (L) channel.
Connect the other ends of these cables to the AUDIO INPUT
terminals on the back of the Projection TV. Make sure these
terminals are in line with the terminal you used in step O.
If your VCR is monaural (non-stereo), only connect a single audio
cable. Connect this cable to the VCR, then c',ormect the other
end of the cable to the L (Left) audio input on the back of tlhe
Projection TV.
If your VCR has a video channel switch with an "OFF/AV" setting,
set the switch to that setting. See your VCR's owner's guide for
more details.
Begin playing a tape on the VCR.
Use the INPUT button on the control panel or on the remote
control to select the input (INPUT-1 or INPUT-2) to which you
connected the VCR.
Basic Connections 33