Specifications - Yamaha MGP32X Owner's Manual

Appendix

Specifications

Electrical Characteristics
0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms
Output impedance of signal generator (Rs) = 150 Ω
Output load impedance = 10 kΩ(TRS phone output), 600 Ω(XLR output)
Nominal fader position is 10dB lower than the maximum position.
All faders are set to nominal position when dedicated in the below.
Frequency Response
Total Harmonic Distortion
(THD + N)
*1
Noise
*2
Crosstalk
@1 kHz
*3
Maximum Voltage Gain
@1 kHz
*1 Noise is measured with a A-Weighting filter.
*2 Crosstalk is measured with a 1 kHz band pass filter.
*3 Maximum voltage gain is measured under the condition that all faders and GAIN knobs are at maximum.
PAN/BAL knob is panned hard left or right.
European Models
Inrush Current based on EN 55103-1:2009
4.5A (on initial switch-on)
3.5A (after a supply interruption of 5s)
Conforms to Environments: E1, E2, E3 and E4
48
MGP32X/MGP24X Owner's Manual
20 Hz to 20 kHz
GAIN knob: min
Refer to the nominal output level @1 kHz
STEREO OUT GAIN knob: min
output level: +14 dBu @20 Hz to 20 kHz
CH INPUT MIC EIN (Equivalent Input Noise): Rs = 150 Ω
GAIN knob: max
STEREO OUT STEREO master fader: nominal
Bus assign switch: off (All)
GROUP OUT GROUP master fader: nominal
Bus assign switch: off (All)
AUX SEND AUX master knob: nominal
CH mix control: min (All)
STEREO OUT Residual output noise
Adjacent Input Between input channels
Input to Output STEREO OUT L, R
PAN knob: panned hard left or right
MONO CH Input MIC to CH INSERT OUT
STEREO INSERT OUT
STEREO OUT
GROUP OUT
MONITOR OUT
PHONES OUT
AUX SEND (PRE)
AUX SEND (POST)
MATRIX OUT
STEREO CH Input to STEREO OUT
GROUP OUT
AUX SEND (PRE)
AUX SEND (POST)
TALKBACK Input to STEREO OUT
UNIT
+0.5/-1.0 dB
0.02 %
-128 dBu
-87 dBu
-90 dBu
-82 dBu
-94 dBu
-74 dB
-74 dB
60 dB
70 dB
84 dB
84 dB
80 dB
69 dB
76 dB
86 dB
90 dB
58 dB
58 dB
50 dB
60 dB
70 dB