iPod/iPhone signal is not
output.
The supported iPod/
iPhone is not recognized.
When a stereo signal is
input, the left and right vol-
ume is different.
The sound level is incon-
sistent, or there is an
unnatural "pumping" in
the sound.
The Leveler is not enabled.
* If any specific problem should persist, please contact your Yamaha dealer.
Is the output signal assignment set appropriately? (page 36)
Is the iPod indicator turned off?
The unit has not recognized your iPod/iPhone. Check which iPod/iPhone models are sup-
ported.
If your iPod/iPhone has not been charged, it may take some time to be recognized by the
mixer.
Please wait.
Is the pan knob set to the center position?
If it is located in the center, try swapping the connections. If the lesser/greater volume signals
are also switched, check the connected device(s).
Is the same type of cable used for the right and left signals?
A cable with resistance lowers the volume.
Are you applying the compressor at an appropriate level?
You might have to lower the COMP knob levels.
Is the GAIN knob on the stereo channels adjusted appropriately?
The leveler may not be enabled if you increase the gain too much.
Troubleshooting
MGP32X/MGP24X
Owner's Manual
41