Leveling Legs; Oven Window - Maytag MER5752BAQ15 Use And Care Manual

Melntenence
Oven Door
Leveling Legs
Note: The oven dooron a new rangemay feel "spongy"
i
when it isclosed, T hisis normaland will d ecrease withuse,
I
To remove:
1. When cool, open the oven door to the first stop position
(opened about four inches].
2. Grasp door at each side. Do not use the
door handle to lift door.
3. Lift up evenly until door clears hinge
arms.
To replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is
completely seated on the hinges. Push down on the top
corners of the door to completely seat door on hinges. Door
should not appear crooked.
Oven Window
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or other
objects.
3. Do not close the oven door until the oven racks are in place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
Be sure the range is leveled when installed. If
the range is not level, turn the leveling
legs, located at each corner of the
range, until range is level.
Oven Light
ANTI-TIP
BRACKET
_LEV_INGLEG
To Replace Oven Light Bulb:
1. When oven is cool, hold bulb cover in place, then slide wire
retainer off cover. NOT[: Bulb coverwill fall if not held in place
while removing wire retainer.
BULB COVER
Removebulb cover and light bulb.
2.
3. Replace with a 40-watt appli-
ance bulb.
4.
Replace bulb cover and se-
cure with wire retainer.
5. Reconnect power to range. Reset clock.
RETAINER
Convenience Outlet
(Canadian models only)
The convenience outlet is located on the
lower left side of the backguard. Be sure
appliance cords do not rest on or near
the surface element. If the surface
element is turned on, the cord and outlet
will be damaged.
The convenience outlet circuit breaker
may trip if the small appliance plugged
into it exceeds 10 amps. To reset the
circuit breaker, press the switch located
on the lower edge of the backguard.
CIRCUIT BREAKER
21