• Level adjustment
• Leveling the washing machine properly prevents
excessive noise and vibration.
Install the appliance on a solid and level floor surface,
preferably in a corner of the room.
• If the floor is uneven, adjust the adjustable feet as
required. (Do not insert pieces of wood, etc. under the
NOTE: Extend tile feet no more than necessary to level
the washer. The more the feet are extended, the
more the washer will vibrate.
• Make sure that all four feet are stable and resting on
the floor and then check that the appliance is perfectly
level (Use a level).
• After the washer is level, tighten the lock nuts up
against of the base of the washer. All lock nuts must
• It is critical to adjust the feet perfectly. This must be
done while the washer is spinning with a load. Use the
wrench (supplied) to adjust the feet until there is no
vibration. Then tighten the lock nuts to prevent further
NOTE: If there are vibration
and noise during the spin
cycle, re-check the leveling of the washer, adjust
the feet as required,
and tighten the lock nuts
securely to prevent changes in adjustment.
Run the washer with a test load to make certain
your washer is properly leveled. Put
6 pounds of laundry in the
machine. Then, press POWER, RINSE+SPIN,
in that order. When the machine
spins at high speed, verify that it is stable. If not,
adjust the feet accordingly.
down the edges of the washing
top plate diagonally,
not move up
and down at all. (Please,
check both directions.)
ff the machine
rocks when pushing
the Jeet again.