INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation. Read and follow the instructions
provided with any tools listed here.
20 Ib LP Gas Models
Natural
Gas Models
Tools Needed
•
Tape measure
•
Wrench or pliers
•
Small, flat-blade screwdriver
•
Pipe wrench
•
Flat-blade screwdriver
•
Scissors or cutting pliers
•
#2 and #3 Phillips screwdriver
(to remove tiedowns)
•
Level
•
Noncorrosive
leak-
detection solution
Tools Needed
•
Tape measure
•
Wrench or pliers
•
Small, flat-blade screwdriver
•
Pipe wrench
•
Flat-blade screwdriver
•
Scissors or cutting pliers
•
#2 and #3 Phillips screwdriver
(to remove tiedowns)
•
Level
•
Noncorrosive
leak-
detection solution
Parts Supplied
•
Gas pressure regulator/hose
assembly set for 11" WCP LP
gas (attached to manifold)
•
1 single-prong
plug/5,000 mAmp transformer assembly
•
Convertible regulator set for 4" WCP Natural gas
•
Orifices for Natural gas conversion
•
LP gas fuel tank tray
Parts Needed
•
20 Ib LP gas fuel tank - approximately
18" (45.7 cm) height
and 12" (30.5 cm) diameter
Parts Needed
•
Gas line shutoff valve
•
1/2"male pipe thread nipple for connection to pressure
regulator
•
LP gas-resistant
pipe-joint compound
•
CSA design-certified
outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply
line as needed.
Parts Supplied
•
Convertible regulator set for 4" WCP Natural gas.
•
Single-prong
plug/5,000 mAmp transformer
assembly