Installation Requirements; Tools And Parts; Location Requirements; Product Dimensions - KitchenAid KBPU182VSS Installation Instructions And Use And Care Manual

Outdoor built-in power burner
Hide thumbs Also See for KBPU182VSS:
Table of Contents

Advertisement

Available languages

Available languages

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Tape measure
Small, flat-blade screwdriver
Flat-blade screwdriver
#2 and #3 Phillips screwdriver
Level
Parts Supplied
Gas pressure regulator/hose assembly set for 11" (28 cm)
WCP LP gas (attached to manifold)
1 single-prong plug transformer assembly
Convertible regulator set for 4" (10.2 cm) WCP Natural gas
Orifices for Natural gas conversion
LP gas fuel tank tray
Parts Needed
20 lb LP gas fuel tank - approximately 18" (45.7 cm) height
and 12" (30.5 cm) diameter

Location Requirements

Select a location that provides minimum exposure to wind and
traffic paths. The location should be away from strong draft
areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for built-in outdoor
Power™ burners:
A minimum of 24" (58 cm) must be maintained between the
sides and back and any combustible construction.
A zero clearance may be maintained below the cooking
surface and any combustible construction.
Ignition
A grounded, 3-prong outdoor GFI outlet is to be located inside
the island cabinet and to the left of the Power™ burner. See
"Electrical Requirements" section.

INSTALLATION REQUIREMENTS

Wrench or pliers
Pipe wrench
Scissors or cutting pliers
(to remove tiedowns)
Noncorrosive leak-
detection solution

Product Dimensions

B
B
A. 18 " (47.9 cm)
B. 10 " (27.0 cm)
C. 22 " (58.1 cm)
D. 23 " (60.0 cm)
E. 22¼" (56.5 cm)
Built-In Outdoor Power™ Burner Enclosure
This built-in outdoor Power™ burner is for installation in a built-in
enclosure constructed of combustible and noncombustible
materials. Some types of noncombustible materials could be
brick, firewall or steel. Some types of combustible materials
could be wood or laminate.
The enclosure for the built-in outdoor Power™ burner is to be a
minimum of 11" (28.0 cm) high x 20" (50.8 cm) deep x
19" (48.6 cm) wide.
A
C
D
E
F
G
H
I
F. Manifold pipe
G. ¼" (8.3 cm)
H. 19
" (50.0 cm)
I. 20
" (53.2 cm)
5

Advertisement

Table of Contents
loading

Table of Contents