Installation Requirements; Tools And Parts; Electrical Requirements - KitchenAid POWER KBPU182VSS Use & Care Manual
Outdoor built-in power burner
Hide thumbs
Also See for POWER KBPU182VSS:
Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION REQUIREMENTS
_?' i_: _ _._1:_
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools Needed
•
Tape measure
•
Wrench or pliers
•
Small, flat-blade screwdriver
•
Pipe wrench
•
Flat-blade screwdriver
•
Scissors or cutting pliers
•
#2 and #3 Phillips screwdriver
(to remove tiedowns)
•
Level
•
Noncorrosive
leak-
detection solution
Parts Supplied
Gas pressure regulator/hose
assembly set for 11" WCP LP
gas (attached to manifold)
•
1 single-prong
plug/2,085 mAmp transformer assembly
•
Convertible
regulator set for 4" WCP Natural gas
•
Orifices for Natural gas conversion
•
LP gas fuel tank tray
Parts Needed
•
20 Ib LP gas fuel tank - approximately
18" (45.7 cm) height
and 12" (30.5 cm) diameter
[,,:}ca ::(_s Reqs,:: te_sle its
Select a location that provides minimum exposure to wind and
traffic paths. The location should be away from strong draft
areas.
Do not obstruct flow of combustion
and ventilation air.
Clearance to combustible
construction
for built-in outdoor
Power
TM
burners:
•
A minimum of 24" (58 cm) must be maintained between the
sides and back and any combustible
construction.
•
A zero clearance may be maintained below the cooking
surface and any combustible
construction.
Ignition
A grounded, 3-prong outdoor GFI outlet is to be located inside
the island cabinet and to the left of the Power
TM
burner. See
"Electrical Requirements"
section.
t
A
q
t
T-
B
L
®
©
A. 18_" (47.9 cm)
B. 10%" (27.0 cm)
C. 22 z_,,(58.1 cm)
D. 23%" (60.0 cm)
E. 22¼" (56.5 cm)
F. Manifold pipe
G. 3¼" (8.3 cm)
H. 191_,, (50.0 cm)
I. 201_,,
(53.2 cm)
Built-In Outdoor Power
TM
Burner Enclosure
This built-in outdoor Power
TM
burner is for installation in a built-in
enclosure constructed
of combustible
and noncombustible
materials. Some types of noncombustible
materials could be
brick, firewall or steel. Some types of combustible
materials
could be wood or laminate.
The enclosure for the built-in outdoor Power
TM
burner is to be a
minimum of 11" (28.0 cm) high x 20" (50.8 cm) deep x
19" (48.6 cm) wide.
Advertisement
Table of Contents
