Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
INSTRUCTIONS
¸G: :iii i
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
•
Unpack grill. Remove all packaging materials and remove grill
from carton.
•
Move grill close to desired outdoor location.
•
Open the hood.
Remove
Packaging
Material
Inside the Grill
6.
On some models, install rotisserie mounting bracket using
2 screws.
A, 2 screws
B. Rotisserie bracket
7. Dispose of/recycle all packaging material.
NOTE: If grill has been converted to LP gas, follow instructions
in
"Conversion
to LP Gas" at the end of this section.
1. Cut the tiedowns holding the grates together.
2. Remove rotisserie skewer (on some models), warming shelf
and grill grates from inside the grill and remove packaging
material.
3. Remove foam block and wrap from inside the grill.
A
Fire Hazard
Do not use grill near combustible
materials.
Do not store combustible
materials near grill.
Doing so can result in death or fire.
• • ....
f
A. Foam block
B. Foam wrap
4. Replace the grill grates.
5. Place warming shelf on brackets as shown.
B
A. Warming shelf brackets
B. Warming shelf
A
Natural Gas Use
The installation of this grill must conform with local codes or, in
the absence of local codes, with either the National Fuel Gas
Code, ANSI Z223.1/NPFA 54, Natural Gas and Propane
Installation Code, CSA B149.1, or Propane Storage and Handling
Code, B149.2.
1. Place grill into outdoor enclosure, but leave enough room in
back to connect to gas supply and electrical plug-in.
Explosion Hazard
Use a new CSA International approved
"outdoor"
gas supply line.
Securely
tighten
all gas connections.
Failure to do so can result in death, explosion,
or fire.
2. Make gas connections.
A combination
of pipe fittings must be used to connect the
grill to the existing gas line.
11
Advertisement
Table of Contents
