Table of Contents
Advertisement
Installation, cont'd
Cabling and Installing the AAPs
The space behind the AAP panel is limited. The online
Connectivity Configurator, available at
www.extron.com, offers guidance as to the fit of AAPs
into this space.
Extron's various single space and double space AAP devices,
including the various RGB 580xi AAPs, can be mounted to the
HSA 822. See appendix A, "Reference Information", for
RGB 580xi AAP part numbers.
The screws for installing an AAP are built into its AAP panel, so
no additional screws are needed.
Ensure that AC power is disconnected before
servicing the HSA unit.
1.
Remove the top and bottom screws on the right and left
sides of the AAP panel (figure 2-4). Retain the screws. Lift
the panel away from the enclosure as far as the connected
cables allow and then allow the panel to dangle,
supported by its connected cables.
The center screws on each side of the AAP panel do not
fasten the AAP panel in place. They secure the
AC power outlet.
Ensure that the edges of the AAP panels do not scratch
the finished surface of the top panel flange when
removing the panels.
2.
Cable the rear of the AAPs before fastening the AAPs to
the AAP panel. Route the cables through the hole in the
underside of the surface mount enclosure and connect
them to the rear of the AAPs. If applicable, refer to the
cabling information in the documentation for the AAP.
3.
Insert each of the AAP's screws through the holes in the
AAP opening of the HSA AAP panel. Secure each AAP to
the panel with the provided captive washers and #4-40
nuts (figure 2-5).
HSA 822 Hideaway
®
Enclosure • Installation
2-8
Remove two
screws ea. side.
Remove panel.
H S
A 8
2 2
Replacement Face Plate
Screws (4) Under Enclosure
Figure 2-4 — Removing the AAP panel from an
HSA 822
AAP Panel
IN P
S E
U T
L E
C T
C O
A U
M P
U T
D IO
E R
RGB 580xi SI AAP
Figure 2-5 — Mounting an AAP device on the AAP
panel
4.
Replace the AAP panel in the surface mount enclosure and
secure it in place with the screws removed in step 1. If you
lose an AAP panel screw, four spare screws are stored in
the underside of the enclosure.
®
HSA 822 Hideaway
Enclosure • Installation
#4-40 Nut w/ Captive
Washer
Cable
H S
A 8
2 2
2-9
Advertisement
Table of Contents
