Kodak EKTAPRO Quick Reference Manual page 25

n
Installing the slide tray
Important note: First switch on the projector before you install the slide tray. This will ensure
that the projector's transport ring is in the zero position. Otherwise the tray cannot be placed
properly and will not be transported.
n
Removing the slide tray
Always lift off the slide tray in the zero position!
(Indication: The tray is in zero position when the green LED at the front of the projector lights up
(not Ektapro 320!))
Move tray to zero position:
a) Using the slide change button on your projector or remote control units
Hold the slide transport-backwards button down. The slide tray goes into rapid
search and stops automatically in the zero position.
b) Using the IR Remote Control
Select "0" on the keypad and confirm with "*". The slide tray moves to the zero
position.
c) Using the mains switch
Turn the projector off by the mains switch. When the projector is turned on again, it will complete
a system check and bring the slide tray back to the zero position!
Removing the slide tray in any position (e.g. after a slide jam)
2.
Lift off the slide tray.
3.
Turn slide tray over and rotate the base plate until it locks
into the zero position, otherwise the slide tray cannot be
replaced on the projector in the zero position. Do not forget
to take the slide out of the slide gate!
Quick Reference -- The ultimate reference for Kodak
Trays
Installation and Removal
1.
Push aside and hold the slide tray lock
EKTAPRO Slide Projectors
25