Change Access Code For Daily Duties (H10) - Panasonic MEW01349 Operating Instructions Manual

Panasonic Electric Works Nordic AB
MEW01349
33
Action
"Access"
Scroll to menu H10.
"↲ "
Enter the old code, the
new code and the new
code again.
Rev: - Operating Instructions Fire alarm system EBL512 G3, V1.1.x
Change access code for daily
duties (H10)
For security reasons, the default code should be changed.
Text in display
H10 Change access code for daily duties
Access code:
New code:
Access code: ****
New code: ****
Incorrect access code, NO change
H10 Change access code for daily duties
NOTE! After change of access code it is recommended do "Safe
shutdown of the control unit" (see menu H8/S8). This will save the
SSW data (e.g. the new code) in a Flash ROM (see page 137).
If the valid access code is unknown a "back door code" is available.
Verify:
Verify: ****
150
Comments
According to chapter
"Access", see page 85.
The digits are replaced by
**** in the display.
The access code was not
correct. Try again.
The access code was
correct and is now changed
to the new code. Scroll to
another menu or press
"ESC".