Complete Installation; Reverse Door Handle; Reinstalling Door - Kenmore HE4 110.9508 Series Use & Care Manual

5. Move hinge to the other side and reattach with the 4 screws
removed in Step 3.
6. Reverse the plastic cover. Slide it up over the inner door
assembly edge and gently snap into place.
Use a small flat-blade screwdriver to remove plug strip from
the door opening. Slide the head of the screwdriver under the
top portion of the plug strip, being certain not to scratch the
dryer surface. Lift up. Repeat in the middle and at the bottom.
Remove the plug strip in the door opening and insert in the
opposite side.
7. Set the inner door assembly aside.
Reverse the door handle
1. Place the outer door assembly face down on work space.
2. Remove the 2 screws that hold the door handle and the
2 screws holding the hole plugs. If hole plugs do not easily fall
out after screws are removed, insert a small screwdriver into
the holes and gently push the plugs out.
A B
A. Door handle
B. Hole plugs
& Move the door handle to the other side and reattach with the
2 screws removed from the door handle in Step 2.
4. Move the hole plugs to the new hinge side and attach with
the 2 screws removed from the hole plugs in Step 2.
Reinstalling the door
1. Check for fingerprints on the glass. Clean the glass if
necessary.
2. Place the inner door assembly into the outer door assembly.
Align the hinge cover and hinge in the openings on each side.
To fit correctly, the inside door assembly edge is completely
inside the outside door assembly edge.
3. Reassemble the inner and outer door assemblies with the
6 screws.
Insert a screw in the 2nd opening from the top of the hinge
opening and partially tighten. Hang the door by placing the
top hinge keyhole over the 2nd screw head and tighten the
screw. By putting this screw in first, the door will hang in
place while you insert and tighten the remaining 4 screws.
A. Dryer door
B. Dryer
C. Insert this screw first
6. Close the door and check that it latches securely.
_ _ _ _ _%_.,,_7_ ._ _ • •
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check tthat you have all of your tools,
3. Dispose of/recycle all packaging materials,
4. Check the dryer's final location. Be sure the vent is not
crushed or kinked,
5. Check that the dryer is level. See "Level Dryer."
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
6. Plug into a grounded 3 prong outlet. Turn on power.
7. Remove the blue protective film on the console and any tape
remaining on the dryer.
13