Download  Print this page

Complete Installation - Kenmore 110.C8756 Series Use & Care Manual

Hide thumbs

Advertisement

Table of Contents
Reverse the strike
1. Use a small flat-blade screwdriver to remove plug strip from
the dryer door opening. Slide the head of the screwdriver
under the plugs, being certain not to scratch the dryer
surface. Lift up.
2. Remove the strike
3. Insert strike on the opposite side.
B
A
A. Plug strip (cannot be seen from this angle)
B. Door strike
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Check the dryer's final location. Be sure the vent is not
crushed or kinked.
5. Check that the dryer is level. See "Level Dryer."
6. Plug into a grounded 4 prong outlet. Turn on power.
7. Remove the blue protective film on the console and any tape
remaining on the dryer.
8. Read "Dryer Use."
9. Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
Reinstall the door
1. Reattach door to dryer front panel with the 4 screws.
2. Check for fingerprints on the glass. Clean glass if necessary.
3. Close door and check that it latches securely.

Complete Installation

10. Select a Timed Dry heated cycle, and start the dryer. Do not
select the Air Only modifier.
If the dryer will not start, check the following:
I
Controls are set in a running or "On" position.
I
Start button has been pushed firmly.
I
Dryer is plugged into a grounded outlet.
I
Electrical supply is connected.
I
Household fuse is intact and tight, or circuit breaker has
not tripped.
I
Dryer door is closed.
11. When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle and
close the door.
If you do not feel heat, turn off the dryer and check the
following:
I
There may be 2 fuses or circuit breakers for the dryer.
Make sure both fuses are intact and tight, or that both
circuit breakers have not tripped. If there is still no heat,
contact a qualified technician.
NOTE: You may notice a burning odor when the dryer is first
heated. This odor is common when the heating element is first
used. The odor will go away.
B
A. Dryer front panel
B. Door assembly
A
13

Advertisement

Table of Contents
loading

  Also See for Kenmore 110.C8756 Series

This manual is also suitable for:

110.c8758 series110.c8757 series