Kenmore HE4 110.9508 Series Use & Care Manual page 15

Gas dryer
Table of Contents

Advertisement

Available languages

Available languages

4.
5.
6.
Adjust Auto Dry Level and/or Options.
NOTE: Auto Dry Level selections
can be made only while
using Auto Dry Cycles. You can select a different dryness
level, depending
on your load, by pressing
Auto Dry Level
and choosing More or Less. Selecting More or Less
automatically
adjusts
the sensed
time needed.
MORE
@
@ LESS
O
AUTO DRY
LEVEL
PRESS & HOLD
SECONDS
TO IOCK
/
UNLOCK CONTROL
Auto Moisture Sensing Controls
When you are using the Auto Moisture Sensing Cycle, the
dryness of the load is determined
by two metal strips
(sensors) located on the inside of the dryer. The metal strips
help "feel" the amount of moisture left in the clothes as they
pass. After the first 5 minutes of an automatic cycle, the
estimated time display will adjust based on the approximate
load size, cycle, dryness level selected and amount of
moisture left in the clothes. When the clothes have reached
approximately
80% of the dryness level selected, the
estimated time display will adjust again, showing the final
drying time.
To use a Manual Cycle
Select a Manual Cycle.
Press MORE TIME or LESS TIME until the desired drying
time is displayed. Tap MORE TIME or LESS TIME and the
time will change by 1-minute intervals. Press and hold
MORE TIME or LESS TIME and the time will change by
5-minute intervals.
NOTE: The More Time and Less Time features can be
used only with Manual Cycles.
O
MORETIME
O
LESSTIME
Press TEMPERATURE until the desired temperature
glows.
NOTE: During a Manual Cycle, you can change the settings
for Time, Temperature, WRINKLE GUARD ®and End of Cycle
Signal. Press PAUSE/CANCEL twice to stop the dryer and
clear the settings. Select another cycle or option.
(OPTIONAL STEP) If desired, select OPTIONS. For more
details, see "Options."
(OPTIONAL STEP) If desired, set the END of CYCLE SIGNAL.
Select HIGH or LOW to alert you when a cycle ends.
Press and hold START for approximately
3 seconds until
dryer starts. Be sure the door is closed.
If you do not press Start within 5 minutes of selecting the
cycle, the dryer automatically
shuts off.
If you wish to end your drying cycle after pressing Start,
press PAUSE/CANCEL twice.
<,op/!:
S _t:;_
Dpver
To stop your dryer at any time
Press PAUSE/CANCEL twice or open the door.
Pausn{i oRRe
To pause the dryer at any time
Open the door or press PAUSE/CANCEL once.
To restart the dryer
Close the door. Press and hold START until dryer starts.
NOTE: Drying will continue from where the cycle was interrupted
if you close the door and press Start within 5 minutes. If the cycle
is interrupted for more than 5 minutes, the dryer will shut off.
Select new cycle settings before restarting the dryer.
Cont ;>l Loc : d
This feature allows you to lock your settings to prevent
unintended use of the dryer. You can also use the Control Locked
feature to prevent unintended cycle or option changes during
dryer operation.
To enable the Control Locked feature:
Press and hold AUTO DRY LEVEL for 3 seconds. Control Locked
glows and a single beep tone is heard. To unlock, press and hold
AUTO DRY LEVEL for 3 seconds. The indicator light turns off.
Properly loading your dryer can lower your utility bill and prolong
the life of your garments.
Loading suggestions
Load the dryer by the amount of space items take up, not by
their weight.
Do not overload the dryer. This causes uneven drying and
wrinkling.
Super Capacity
Dryers
Heavy Work Clothes
4 jeans
2 sweatpants
4 workpants
2 sweatshirts
4 workshirts
Towels
10 bath towels
10 hand towels
14 washcloths
Mixed Load
3 sheets (1 king, 2 twin)
9 T-shirts
4 pillowcases
9 shorts
3 shirts
10 handkerchiefs
3 blouses
©rj'n 9 and
e Tps
Se(ect the correct cyc(e and dryness (eve( or temperature for your
load. If an Auto Dry Cyc(e is running, the disp(ay shows the
estimated cyc(e time when your dryer is automatically
sensing
the dryness (eve( of your bad. If a Manual Cyc(e is running, the
disp(ay shows the exact number of minutes remaining in the
cycle.
Cool Down tumbles the load without heat during the last few
minutes of all cycles. Cool Down makes the loads easier to
handle and reduces wrinkling. The length of the Cool Down
depends on the load size and dryness level.
Drying tips
Follow care label directions when they are available.
If desired, add a fabric softener sheet. Follow package
instructions.
15

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents