Jenn-Air PRO-STYLE JDS8860BDP16 Use & Care Manual page 12

Oven will not self=clean.
Oven did not clean properly.
Oven door will not unlock after
self=clean cycle.
There are no beeps and
no display.
Moisture collects on oven
window or steam comes from
oven vent.
There is a strong odor or light
smoke when oven is turned on.
Fault Codes
Noises may be heard.
SABBATH displayed
continuously.
Cannot add another Favorite.
Check to make sure the cycle is not set for a delayed start. See pg. 5.
Check if door is closed.
Check if control is in Sabbath Mode. See pg. 28.
Oven may be over 400° F. Oven temperature must be below 400° F to program a
clean cycle.
Longer cleaning time may be needed.
Excessive spillovers, especially sugary and/or acidic foods, were not removed prior
to the self-clean cycle.
Oven interior is still hot. Allow about one hour for the oven to cool after the
completion of a self-clean cycle. The door can be opened when the LOCK indicator
word is not displayed.
The control and door may be locked. See pg. 15.
Oven may be in Sabbath Mode. See page 28.
This isnormal when cooking foods high in moisture.
Excessive moisture was used when cleaning the window.
This isnormal for a new range and will disappear after a few uses. Initiating a clean
cycle will "burn off" the odors more quickly.
Turning on a ventilation fan will help remove the smoke and/or odor.
Excessivefood soils on the oven bottom. Use a self-clean cycle.
The oven may detect a fault during programming or during operation. If a fault is
detected, the message FAULT DETECTED- DISABLE POWERTO CLEAR or FAULT
DETECTED- PRESSENTERTO TRY AGAIN may appear. Follow directions in the display.
If the fault reappears or does not clear, call an authorized servicer or the toll-free
number in the display.
If the same operation is attempted before having the oven repaired, the message
FEATURENOT AVAILABLE will appear. The feature will remain inoperableuntil service
is obtained.
If the oven is heavily soiled, excessive fiareups may result in a fault code during
cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out
excess soil, then reset the clean cycle. If the fault code reappears, contact an
authorized servicer.
The oven makes several low-level noises. You may hear the oven relays as they go on
and off. This is normal.
As the oven heats and cools, you may hear sounds of metal parts expanding and
contracting. This is normal and will not damage your appliance.
Oven is in Sabbath Mode. To cancel, press and hold the Setup pad for five
seconds.
Favorites is full. To delete a favorite and add another, see page 26.
11