Table of Contents
Advertisement
General
Care & Cleaning
FEATURE
OVERVIEW
Removing & Replacing Warmer Drawer
Pullup withfinger
To Remove
and Replace Warmer (Warm & Ready
TM)
Drawer
Left Gfide
To Remove Warmer Drawer:
1.
_
Turn power off before removing the Warmer Drawer.
2.
Open the drawer to the fully opened position.
3.
Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever.
4.
Pull the Warmer Drawer away from the range.
To Replace Warmer Drawer:
Push down with finger
Fig. 1
1,
2.
3.
Pull the bearing glides to the front of the chassis glide (See Fig. 2).
Align the glide on each side of the drawer with the glide slots on the range.
Push the Warmer Drawer into the range until levers "click"
(approximately
2"). Pull the drawer open again to seat bearing glides into
position. If you do not hear the levers "click"
or the bearing glides
do not feel seated remove the drawer and repeat steps 1-3. This wilt
minimize possible damage to the bearing glides.
Fig, 2
Oven Lights
FEATURE
OVERVIEW
Operating Oven Lights
Replacing Oven Light
_Vire
Holder
Fig. 3
Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
Be sure the range is unplugged and all parts are
COOL before replacing oven light(s). Wear a leather-faced
glove for
protection against possible broken glass.
To Operate the Oven Lights
Both of the interior oven lights automatically turn on when the oven
door is opened. Press _
to turn the lights ON and OFF when the
oven door is closed. Each oven light is located at the rear wall of the
oven interior and is covered with a glass shield held by a wire holder
(See Fig. 3). The Glass Shields must be in place whenever the oven
is in use.
To
Replace
the Oven
Light(s):
1.
Turn electrical power off at the main source and unplug the
range.
2.
Press wire holder to one side to release the glass shield.
3.
Replace the old bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder into place.
5.
Turn power back on again at the main source (or plug in the
range).
6.
The clock wilt then need to be reset. To reset, see Setting the
Clock in this Use & Care Guide.
35
Advertisement
Table of Contents
