Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle - Kenmore 665.15924 Use & Care Manual

Use this cycle for pre-
rinsed or lightly-soiled
loads. This cycle
automatically adds a fill
Use main detergent
and brief pre-wash, dispenser section.
purging the hot water line
and improving wash
results, without adding
time for water heating
periods.
Initial display time: 48 rain
FlrstFill Wash Main Rinse Rinse Final Dry Time Water
Water Wash Heated |rain) Usage
Temp. Rinse (gel/L)
Greater • • • • 48* 5.2-6.7/
than 19.7-25.4
135°F
Less • • • • • 44* 6,9-_4/
than 26.1-31,8
135°F
(57°c)
Use this rinse cycle for rinsing _F_
(_'IcK_ dishes, glasses, and silverware
L=JU
that will not be washed right
away. Do not use
Initial display time: 10 rain detergent with
this cycle.
Wash Main Rlns_ Rinse Final Dry Time Water
Wash Heated (mln) Usage
Rinse (gel/L)
•
10 IJ_-2.1/
6.8-7.9
NOTE: The sensor in your dishwasher monitors the soil level.
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance.
Canceling a Cycle
Anytime during a cycle, press
The display shows
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light turns
off. Select a new cycle and options.
To stop the drain
You can press CanceVDrain again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
To clear the indicators
Press CanceVDrain before starting the dishwasher to clear all
options and cycles.
Changing a Cycle or Setting
During the first fill of a cycle
1. Press a new cycle and/or options.
2. Check the detergent dispensers. They must be filled prope=
for the new cycle.
After the first fill of a cycle
1. Press
The display shows
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasherdoes not need draining, the light
turnsoff.
2. Check the detergent dispensers. They must be filled proper
for the new cycle.
3. Close the door.
4. Press a new cycle and/or options.
5. Press START.
Adding Items During a Cycle
You can add an item anytime before the main wash starts. Ope
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1. Lift up the door latch to stop the cycle. Wait for the sprayin_
action to stop before opening the door.
2. Open the door. If the detergent dispenser cover is still close*
add the item.
3. Close the doer firmly until it latches. The dishwasher rssume
the cycle after about -,a5 second pause.
14