Dishwasher Feedback Section; Canceling A Cycle; Changing A Cycle After Dishwasher Is Started - Kenmore ULTRACLEAN 665.1456 Series Use & Care Manual

Delay Hours
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak
hours when possible. Delay displays how many hours before the cycle will begin.
To delay the start:
1. Select a wash cycle and options.
2. Press the DELAY HOURS button to choose the number of hours to be delayed.
3. Press START/RESUME to begin the delay countdown.
NOTE: Anytime the door is opened for more than 3 seconds (such as, to add a dish), the Start/Resume button must be pressed
again to resume the delay countdown.
Cycle Indicators and Time Display
Selecting Cycles and Options
1. To repeat the same cycle and options used on the previous cycle, press START/RESUME once to show which selections you
used. Press START/RESUME again and close the door within 4 seconds to run the cycle. If the door is not closed in time, the
dishwasher will beep several times and will not start.
2. To start a new cycle, select the desired cycle and options, then press START/RESUME and close the door within 4 seconds to
run the cycle. If the door is not closed in time the dishwasher will beep several times and will not start. Not all options are
available for every cycle. If an invalid option is selected for a given cycle, the lights will flash.
Turning On/Off the Sound
Press and hold HIGH TEMP WASH for 3 seconds to toggle sound on and off. The sound will not be deactivated for
cycle interruption.
1. To cancel selections and/or drain, press and hold the START/RESUME button for 3 seconds. If you drain the dishwasher by
selecting CANCEL/DRAIN, the LED will turn on. The door must be closed for the drain to begin.
2. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the dishwasher drain completely. The
Cancel/Drain light will turn off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. See steps in the previous "Canceling a Cycle" section for canceling the current cycle.
2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before
restarting your new cycle.
3. Select a new cycle and options.
4. Press START/RESUME.
18

Dishwasher Feedback Section

The Status display is used to follow the progress of the dishwasher cycle and to show
other information.
The indicators glow when the dishwasher is washing, drying, complete, and/or sanitized.
Estimated cycle time is displayed in hours and minutes as you make cycle and option selections.
After you start the dishwasher, the display counts down the time.
When you select the Delay option, the Time display will give the number of hours followed by
an "H."
The indicator light will glow blue for wash, red for dry, and green for cycle complete.

Canceling a Cycle

Changing a Cycle After Dishwasher is Started