Amana ABD2233DEQ Use & Care Manual page 8

3. Locate handletrim in literaturepackand
installovertop andbottomof handle, a s
illustrated.
* Secure top handle trim with remaining
screw removed in step 1.
Snap bottom trim over bottom portion
of handle.
To Remove:
1. Remove top handle trim by removing
top handle screw.
• Retain trim and screw for later
replacement.
2. Pry bottom handle trim from handle with
screwdriver flat blade wrapped in
masking tape.
• Retain trim for later replacement.
3. Remove two hex head screws.
* Retain screws for later replacement.
Side Mount Handle
Materials Needed
* Phillips screwdriver
To Install:
1. Remove screws from the side of the
doon
2. Align the side mount handle with the
predrilled holes in the door panel.
3. insert the screws in the sequence as
shown.
4_
Lower
Handle
4. Ensure the door handle is snug to the
door panel.
To Remove:
Reverse installation procedure.
Freezer Handles
Partial-Width Handle
Materials Needed
* Phillips screwdriver
To Install:
1. Install handle by fastening with
screws removed from edge of door.
If reversing freezer door, remove
door plugs from top edge of door
and insert into screw holes.
To Remove:
1. Remove handle screws with Phillips
screwdriver and retain screws for
later use.
t II
Front Mount Freezer Handle
Materials Needed
Gloves to protect hands.
Phillips screwdriver.
• Plastic handle removal card (or '_2" thick plastic
card:). Retain the card.
Notes:
There is a slight curve to
this style of freezer
handle.
,, For proper installation, be
sure handle is oriented as
shown.
To install:
1. Align door handle clips slightly to the left of the
tabs attached to the freezer door.
2. Rotate the handle so the left base is flat against
the door.
Handle Door