JVC EXAD KD-AV7000 Instructions Manual page 51

D (Dynamic). RANGE COMPRESSION
You ca_ e_,ioy a powerful sotmd even at a low
volume level by compressiug dy_mnic range
(diffcre_ce between the lowest and the highest
frequency sounds).
* This takes ef*_ct Rw all the playback sources,
• OFF:
• MiD:
• MAX:
Select when you wa,lt to e*!,ioy
playback
with its full dynamic
rauge
0_o etfcct applied).
Select when you warn to reduce the
dy_mmic range a little.
Select whe_ you want to apply tile
compress
efJ-'cct flllly
(useflll at a
low volume level).
• SUBWOOFER:
Select _YES" (COmlected) or "NO"
(disconuected).
• SUBWOOFER PHASE:
Select either "NORMAL" or "REV.
(reverse)" to obtain better subwoofcr
som_ds.
* These settings are very related to one another;
ther@>_, one setting is changed, some other
setHtlgs will be changed automatically and
appr{&riately (see page 73).
, Sound c'omes out oj'the subwoq¢k'r_br Dolby
Pro Logic' II on@ when either the.fl_mt spea#ers
or the center streaker is set m "SMALL."
CROSS OVER
You cal_ seJect the crossover fl'equency l\}r the
small speakers used. The sig_mls below the
preset frequeucy level will be sent to tile
subwoo_cr (or to tile _'LARGE" speakers when
"SUBWOOFER" is set to "NO").
SPEAKER SIZE
Set speaker infbrmation correctly.
• FRONT/CENTER/REAR:
Set the speaker size properly.
LARGE: If the c(me speaker size is
more tba*_ 13 cm (5-7_ in.)
SMALL: If tile cone speaker size is
less than 13 cm (5-74 m.)
NONE: If *_ot used.
AMP GAIN
You cau change _he ma×immn volmne [eve[ of
this unit. Whe_ the ]naxhnum po'_ver of the
speakers is less than 50 W, select LOW"
to prevera
them t)'om being damaged.
• HIGH:
• LOW:
You can adjust the volume level
fl'om "0" to "50."
_tbu can adjust the volume level
from "0" to "30."