LIFESTYLER 831.297033 Owner's Manual page 12

6. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON
a,
b.
c.
If the walking belt has shifted to the left, first remove the
safety key from the console and UNPLUG THE POWER
CORD. With the allen wrench included, turn the left rear
roller adjustment bolt clockwise, and the right bolt
counterclockwise, 1/4 of a turn each. Plug in the power
cord and reinsert the safety key. Run the treadmill for a
couple of minutes. Repeat as necessary until the walking
belt is centered.
If the walking belt has shifted to the right, first remove the
safety key from the console and UNPLUG THE POWER
CORD. With the allen wrench included, turn the left rear
roller adjustment bolt counterclockwise, and the right bolt
clockwise, 1/4 of a turn each. Plug in the power cord
and reinsert the safety key. Run the treadmill for a
couple of minutes. Repeat as necessary until the walking
belt is centered.
If the walking belt slips when walked on, first remove the
safety key from the console and UNPLUG THE POWER
CORD. With the allen wrench included, turn both rear
roller adjustment bolts clockwise, 1/4 of a turn. Plug in
the power cord and reinsert the safety key. Run the
treadmill for a couple of minutes. Repeat as necessary
! i
until the tension of the walking belt is correct. When the tension is correct, you should be able to
lift each side of the walking belt 3-4 inches off the walking platform. The center of the walking
belt should remain just at the surface of the walking platform. Be careful to keep the walking belt
centered on the walking platform.
7. SYMPTOM: THE TREADMILL DOES NOT INCLINE
a. Stand at the back of the foot rails while increasing the incline. Stand at the front of the foot rails
and lean forward while decreasing the incline. (See OPERATION AND ADJUSTMENT in this
manual.)
STORAGE
Unplug the power cord when the treadmill is not in use. Remove the bolt and nut from the lower end of
the handrail. Loosen the upper end of the handrail and remove the handrail. Loosen the lock knob,
and carefully lay the upright and handrail on the treadmill. Keep all hardware in a secure location.
The allen wrench can be stored conveniently by removing the
backing from the wrench clip and pressing it onto one of the
endcaps.
12