LIFESTYLER 831.297033 Owner's Manual page 11

2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Check the circuit breaker located on the treadmill frame near the power cord. If the circuit
breaker has tripped, the switch will protrude. (See the drawing above.) To reset the circuit
breaker, wait for five minutes and then press the switch back in.
b. Make sure the power cord is plugged in.
c. Remove the safety key from the base console. Reinsert the safety key fully into the base
console. Various indicators on the base console should light.
3. SYMPTOM: THE CONSOLE DOES NOT FUNCTION PROPERLY
a.
If a console malfunction occurs, an error code may appear on the console: four E's or a PO on
the display. If an error code appears, remove the safety key, wait for ten seconds and then
reinsert the safety key. If the error code appears again, call our Customer Service Department.
Do not operate the treadmill until the problem is corrected.
4. SYMPTOM: THE PULSE EARCLIP DOES NOT FUNCTION PROPERLY
a. Make sure the pulse earclip is plugged fully into the jack on the console. Rub your left ear lobe
and reposition the earclip. Attach the clothes clip to your collar.
b. Try standing still while measuring your pulse.
c. The pulse earclip may need to be cleaned. Press the earclip open, and wipe the two clear
circles inside the earclip, using a cotton swab saturated with denatured alcohol.
WARNÁNG:
The pulse earcllp Is not a medical device. Various factors, Including the
user's movement while exercising, may affect the accuracy of heart rate readings. The
earcllp Is Intended only as an exercise aid In determining heart rate trends In general.
5. "SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. Walk on the treadmill for 10 minutes to break in the walking platform. During this break-in period,
it is normal for the walking belt to slow.
b. If an extension cord is needed, use only a 14-gauge general-purpose cord of approximately five
feet in length.
C,
If the walking belt is overtightened, treadmill performance
may be reduced and the walking belt permanently
damaged. Remove the safety key and UNPLUG THE
POWER CORD. With the allen wrench included, turn
both rear roller adjustment bolts counterclockwise, 1/4 of
a turn. Plug in the power cord and reinsert the safety
key. Run the treadmill for a couple of minutes. Repeat
until the tension of the walking belt is correct. When the
tension is correct, you should be able to lift each side of
the walking belt 3-4 inches off the walking platform. The
center of the walking belt should just touch the surface of
the walking platform. Be careful to keep the walking belt
centered on the walking platform.
Rear Roller Adjustment Bolt
11