Table of Contents
Advertisement
Turning DVD Video Camera/Recorder
On and
Off
While holding
down
the gray button at the right
of power
switch, set the switch according
to
each recording
function:
Set
to "OFF":
Tile DVD video camera/
recorder
will turn off
Set to "D":
To record
still on SD
Illen/O
rv
card
Set to "411":
To record movie on DVD-
RAM/DVD-RW/DVD-R/
+RW disc
-Set to "1_1":
To record still on DVD-
RAM disc
Note:
• Once you turn the DVD video camera/recorder
on to
let it recognize the disc, you can immediately
record
or play back by turning the DVD video camera/
recorder on again. However, if a long time has
elapsed after the disc was inserted, it will take some
time for the DVD video camera/recorder
to start
because
it must recognize the disc again (see
"Troubleshooting"
on page 135),
• It will take some time for the DVD video camera/
recorder to display the Disc Navigation screen after
power is turned on,
• When the DVD video camera/recorder
is turned on,
the self-diagnosis
function will work and a message
may appear. In this case, refer to "Trouble Messages"
on page 129 and take corrective action.
Power ON status
During playback,
set the power
switch
to %1'
or "1_1" when using disc, or set it to "[i_ril" when
using card.
Turn the switch while
holding down the gray
button at the right of switch,
Power switch
29
Hide quick links:
Advertisement
Table of Contents
