Hitachi DZ-GX5080A Instruction Manual page 129

|
Cannot combine. Select only movies and combine them.
Deselect PHOTO 79
scenes.
Cannot combine. Select Select a range of at least 2 scenes to be combined, and then
79
multiple scenes, combine them.
Cannot delete scenes. This may occur when scene that was edited for division, etc. is to
be deleted. 77, 79
Combine the divided scenes, and then delete them.
Cannot divide scene. This message will appear when the scene is extremely short 78
because division, etc. was repeated.
Cannot execute. This message will appear if you attempt to combine or move
Change display scenes with "Category: VIDEO or PHOTO" specified. 102
category to ALL.
Cannot execute. Division or change in thumbnail was executed when multiple
Unselect multiple scenes were selected. 73
scenes.
Cannot read disc. Error occurred while the disc was being recognized. Make sure
Check dirt/crack/both- that there is no scratch or dirt on disc, that the surface/back of
sides contrary/inserted disc is not reversed, and that the disc is firmly pushed against the 10, 36
correctly, turntable. See *3 and *4 on page 135.
CANNOT RECORD • This message will appear when the PHOTO button is pressed
PHOTOS with the power switch set to "4m".
• You cannot record still image on DVD-RW/DVD-R/+RW disc 21,145
(recordable of still images from PC). Use DVD-RAM disc to
record still images.
CANNOT RECORD This message will appear when the REC button is pressed with 40
VIDEO the power switch set to "1_1" or "[_".
Cannot replace The thumbnail of a still cannot be changed.
thumbnail on PHOTO Select a movie. 82
scenes.
Cannot select any more The maximum number of selectable scenes is 999.
85
scenes.
CANNOT SLEEP
MODE
41
The DVD video camera/recorder can enter the sleep/restart
status only from the recording pause status. The following
conditions apply:
• No disc or card is loaded.
• The disc or card has no remaining space.
• The power switch is set to "1_1"with a DVD-RW (VF-mode)/
DVD-R/+RW.
Remaining space is only enough to record less than 10 stills.
Delete unnecessary stills and try the card, or use another card.
• The card terminals may be dirty: Wipe off dirt, and try the card
again, or use another card.
• Data other than still image may be included: Use another card.
Was the card formatted on PC? Was formatting interrupted
midway? When using the card on this DVD video camera/
recorder, choose "YES" and format it.
CARD ALMOST FULL 77, 98, 145
Card error has
occurred. 23
Card error has
occurred. 97
Format the card now?
130