Assembly; Fitth_G The Loop Handle; Fitting The Trimmer Guard And Trimmer Head - Husqvarna 125L Operator's Manual

ASSEMBLY
NOTE: Make sure unit is assembled cor-
rectly as shown in this manual.
Fitting the loop handle
• Position the handle on the shaft. Note
that the handle must be mounted be-
tween the two arrows on the shaft,
I
• Fit the screw, securing plate and wing
nut as shown in the diagram.
• Tighten the wing nut.
Fitting the trimmer guard and
trimmer head (Model 125L)
• Fit the correct trimmer guard (A) for use
with the trimmer head. Hook the trimmer
guard/combination guard onto the fitting
on the shaft and secure with the bolt (D).
]-_ D B
i C
I
A
• Fit the drive disc (B) on the output shaft.
• Turn the shaft until one of the holes in the
drive disc aligns with the corresponding
hole in the gear housing.
• Insert hex wrench (C) in the hole to lock
the shaft.
• Screw on the trimmer head (H) in the op-
posite direction to the direction of rota-
tion.
H_ WlL
• To dismantle, follow the instructions in
the reverse order.
Fitting the trimmer guard and
trimmer head (Model 1250)
• Fit the correct trimmer guard (A) for use
with the trimmer head. Hook the trimmer
guard/combination guard onto the fitting on
the shaft and secure with the wing nut (B).
• Fit the dust cup (C) on the shaft. The nut
must be completely covered by the dust
cup.
• Hold the dust cup with a wrench to pre-
vent the shaft from rotating.
• Screw the trimmer head (D) onto the
shaft.
• To dismantle, follow the instructions in
the reverse order.
13