Feature - Hoover U5786-900 Owner's Manual

ON-OFF switch
Plug cord into electrical outlet.
To turn cleaner ON, push switch up.
To turn cleaner OFF, push switch down,
Transporting Carrying
cleaner oeaner
Handle positions
l_JE!
To move your The cleaner can
cleaner from room also be moved by
to room, put handle using the carrying
inupright
position, handle.
tilt cleaner back
on rear wheels and
push forward.
The handle of your cleaner has three
positions; upright for storage and when
using cleaning tools; operating position for
general operation on carpet and floors; low
for reaching under low furniture. Step on
handle release lever to lower handle.
Embedded DirtFINDEW Mfeature
{available on some models)
With red and green
lights {A), the
DirtFINDER "_sys-
tem aterts the user
to areas of carpet
that may need more
cleaning atten-
tion. It is able to
sense when larger
amounts of dirt
partides, especially
embedded dirt, are removed.
To let you know that the DirtFINDER
TM
feature is ready, the red light will come on
when the cleaner is first turned on. After a
few seconds, the red light will go off and
the green light wilI come on. Cleaning may
then begin.
- The red light may seldom come on dur-
ing cleaning, this means that your cleaner
is picking up primarily fine surface
dust
and lint which the system may not detect,
or that the carpet is generally clean. To
increase the feature's sensitivity to dirt, set
the switch {B) to the "HI" position.
• At other times, the red light may stay on
for a considerable amount of time. This
means that the carpet contains a high level
of dirt which is being removed by the
cleaner. To decrease the feature's sensitivity
to dirt, set the switch to the "REg."
(Regular) position.
The green light witt remain on throughout
cleaning, except when the detector senses
that a larger amount of dirt is being picked
up; then the red light will come on.
When the red light is on, you should take
additional cleaning strokes in the area until
it changes to green.