Hoover U5786-900 Owner's Manual page 7

Carpet height adjustment
The cleaning of
carpet and rugs
takes place at the
nozzle (t2}.
When it is neces-
sary to raise and
lower the nozzle for
various carpet pile
heights, slide the
nozzle control knob
(D) to the desired
setting,
Handle position
For ease in sliding knob, place handle in the
upright position and tilt cleaner foward (E).
The nozzlewill not move into the adjusted
position until the cleaner handle is lowered
to the operating position {F).
Settings
For maximum cleaning performance, the fo -
lowing carpet height settings are
recommended,
• Lowest setting: for bare floors and all
types of carpet
Note: ]f the cleaner is difficult to push, slide
knob to the next higher setting.
• Higher settings: for very deep pile carpet
where easier pushing effort is desired, while
maintaining good cleaning performance.
Cleaning lightweight
flexible rugs
_ Stand on one end
of rug and move
cleaner toward
other end or edge,
Before reaching .
edge, push down
on handle, This will
lift up the nozzle
(front of cleaner}
and will prevent
rug from dinging
to cleaner, Continue
to lift up nozzle so that when you have
reached the edge, it is completely off the
rug. Move cleaner back to start again, lower
_ozzle, and use onlyforward strokes.
Edge cleaning Stair cleaning
Special edge
groomers are pro-
vided on both sides
of the nozzle to
remove dirt in car-
pet near baseboards
and furniture.
Guide either side of
nozzle parallel to
edge of carpet or
furniture. Use the hose and powered hand tool (some
models} or furniture nozzle for stair clean-
ing. Clean from bottom to top.
When using cleaning tools, the agitator will
continue to rotate,
CAUTION: To avoid personal injury or unnec-
essary wear to carpet, and to prevent tee
cleaner from falling, always place it at bot-
tom of stairs,