T3 Replacing Edge Oroomers; Replacing Power Hand Tool; Agitator Brush Roll - Hoover U5786-900 Owner's Manual

The edge groomers
When to replace
The edge groom-
ers, located on both
sides of the nozzle,
should be replaced
when they appear
worn.
What to buy
When purchasing
edge groomers, ask
for HOOVER part
No. 39511018,
How to replace
Disconnectcleaner
from electrical
outlet.
Remove bottom
plate as described
in "The belt" sec-
tion (Fig. 3-13).
Installing
groomers
Lift off both old
edge groomers
and slide new edge
groomers into posi-
tion as shown.
Reposition bottom
plate and secure
with 4 Phillips head
screws,
Powered hand tool
(some models only)
Agitator brush roll replacement
When agitator brush roll brushes are worn, the brush roll should be replaced. Ask for HOOVER
tort No. 48414150.
How to replace
1, Remove tool
from hose and turn
it so bottom faces
up. Press the latch-
es on either side
of tool and remove
bottom plate (A}.
2. Unscrew the two Phillips screws and
remove belt guard {B).
D
3. Remove agita-
tor including end
plates (C] and dis-
card.
4. Inspect belt to
ensure that it is in
good condition.
If belt is cracked,
gouged or broken,
replace it (see fol-
lowing section).
5. tnsert brush roll
through belt and
position belt over
gear teeth [D) on
brush roll.
I
14
6. With curved
ends down, slide
end plates (C) of
brush roll into slots
[E} on tool.
B
Z Replace belt
guard (B) making
sure not to pinch
brush bristles in
guard. Turn agita-
tor, making sure it
rotates freely.
Replace and tighten
screws.