Related Manuals for Hoover U57809RM Windtunnel Cyclonic
Summary of Contents for Hoover U57809RM Windtunnel Cyclonic
- Page 1 Owner’s Manual Operating and Servicing Instructions ® Windtunnel Cyclonic U57809RM REMANUFACTURED Review this manual before operating the cleaner. www.hoover.com ÿ 2 008 All rights reserved. #17-01-58-058-00-H301 #59881086. 6/08...
-
Page 2: Table Of Contents
Parts & accessories mail reorder form ........17-18 If you need assistance: Visit our website at hoover.com. Click on the “Customer Service” link to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. -
Page 3: Important Safeguards
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Sales and Service Center or Authorized Hoover Warranty Service Dealer (Depot). -
Page 4: Cleaner Assembly
1. CLEANER ASSEMBLY Carton contents A. Handle section B. Cleaner base and upper housing assembly C. Cleaning tools and wands D. Powered Hand Tool Remove all parts from carton and identify each item shown. Make sure all parts are located before disposing of packing materials. -
Page 5: How To Use
2. HOW TO USE Cleaner Description 1. Soft Touch handle grip 2. ON/OFF switch 3. Hose 4. Dirt cup release button 5. Dirt cup assembly 6. Hose handle 7. Cord reel window 8. Headlight 9. Nozzle control knob: turn knob to correct setting for height of carpet being cleaned. - Page 6 Cord Transporting Handle Rewind Cleaner Positions Grasp the end The handle of the plug of your and pull to cleaner release cord has three from cord positions; reel. After upright for desired cord storage and length is when using reached, the cleaning cord will lock tools;...
-
Page 7: Cleaning Tools
3. CLEANING TOOLS Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas. The cleaner is ready for tool use when handle is in upright position. The agitator brush roll will not rotate when the cleaner is in the upright position or the if the agitator brush roll shut off indicator is in the OFF position when the handle is lowered. -
Page 8: Maintenance
Stair Cleaning Use the hose and powered hand tool for stair cleaning. Clean from bottom to top. CAUTION: To avoid personal injury or unnecessary wear to carpet, and to prevent the cleaner from falling, always place it at bottom of stairs. Extra Reach ™... -
Page 9: Filters
Dirt Cup (cont.) How to Empty Press dirt cup release button (A) and pivot Holding dirt cup over trash receptacle, press cup out. dirt cup door release button (A) to open dirt cup door (B). Close door and press dirt cup door release button to latch dirt cup door closed. -
Page 10: Headlight
Secondary Filter: What to Buy When purchasing a new secondary filter cartridge, ask for HOOVER part No. 93002517. To purchase a new black foam filter, ask for HOOVER part No. 93002518. HEPA Final Filter: How to Clean Disconnect cleaner from electrical outlet. -
Page 11: Belt
(B) next to pulley. Belt will “pop” into place. roll through belt and position belt in V-Belt: What to Buy groove (A) on agitator Use only genuine HOOVER belts with your cleaner. When purchasing a brush roll. new belt, ask for V belt - HOOVER part No. 40201-200. -
Page 12: Agitator Brush Roll
Reposition flat belt and bottom plate (Figs. 4-15 Agitator Brush Roll: What to Buy to 4-16). When purchasing a new Agitator Brush Roll, ask for HOOVER part No. 93002361. Powered Hand Tool Replacing Agitator Brush Roll When agitator brushes are worn, the brush roll should be replaced. -
Page 13: Agitator Brush Roll
Agitator Brush Roll: What to Buy and snap closed. When purchasing a new Powered Hand Tool Agitator Brush Roll, ask for HOOVER part No. 48414-088. Belt Replacement The powered hand tool belt is designed to last a long time and is not normally replaced. However, if the belt is cracked, gouged or broken, it should be replaced. -
Page 14: Lubrication
The agitator brush roll is equipped with two ball Cleaners - Household” bearings that should be lubricated periodically -OR - by a Hoover Sales and Service Center or an • checking the Service section of Hoover on-line Authorized Hoover Warranty Service Dealer. at hoover.com -OR - •... -
Page 15: Troubleshooting
1. Bulb burnt out. 1. Replace bulb - Pg. 10. working 2. Loose electrical wires. 2. Call 1-800-944-9200 for nearest authorized Hoover dealer. ® Cleaner is difficult 1. Carpet height setting is incorrect. 1. Set carpet height adjust lever to appropriate to push or won’t... -
Page 16: Clearing Blockages
Clearing Blockages Disconnect cleaner from electrical outlet. Low suction or pick up may be due to a blockage in the system. Refer to the following steps to check for blockages continuing with each step until the blockage is found: Fullness of Check Airflow Check Secondary Dirt Cup... -
Page 17: Parts & Accessories Mail Reorder Form
Parts and Accessories MAIL ORDER FORM Detach this section and mail to: The Hoover Company 7005 Cochran Road • Glenwillow, Ohio • 44139 Attn: Sales & Service Center Item Part Qty/ Price/Pk. Qty. Total Description HEPA Final Filter 93002360 $ 8.99... - Page 18 Signature (req.) ______________________________________________________ Replacement parts and accessory items may be purchased from your Authorized Hoover Dealer, Leading Retailers, Hoover Sales & Service Centers, on-line at www.hoover.com, or by completing this order form. Mail orders limited to U.S. residents only. OR on-line at hoover.ca In Canada, please call 1-800-263-6376 Please allow 3-4 weeks for delivery.