Embedded Dirt Findertm Feature; Some Models Only - Hoover Dirt FINDER Owner's Manual

Embedded Dirt FINDERTM feature

(Some models only)

The ' Dirt FINDER' system alerts the user to areas of carpet that may
need more cleaning attention by sensing a larger amount of dirt par-
ticles being removed, especially embedded dirt.
To let you know that the 'Dirt
FINDER' feature is ready and that
the battery is good, the red light
first turned on. After a few
seconds, the red light will go off
and the green light will come on.
Cleaning may then begin. (If
neither the red nor the green light
comes on, the battery may need
to be replaced. See "Mainte-
nance" section.)
The green light will remain on throughout cleaning except when the
detector senses that a larger amount of dirt is being picked up; then
the red light will come on.
When the red light is on, you should take additional cleaning strokes
in the area until it changes to green.
The red light may seldom come
l
on during cleaning. This means
that your cleaner is picking up
primarily fine surface dust and lint
which the system may not detect,
or that the carpet is generally
clean. To increase the feature's
sensitivity to dirt, set the switch
to the "Hi" position.
At other times, the red light may
l
stay on for a considerable
amount of time. This means that
the carpet contains a high level of
dirt which is being removed by
the cleaner. To decrease the
feature's sensitivity to dirt, set
the switch to the "Reg." (regular)
position.
(Note: On some models this
position is indicated as "Lo".)
9
II WI
I
I
SENSITIVITY
SWITCH \
I
I