Thermal Protector; Authorized Service - Hoover U5786-900 Owner's Manual

Thermal protector
An internal thermal protector has been
designedintoyour cleaner to protect it
from overheating.
When the thermal protector activates, the
cleaner will stop running, If this happens,
proceed as follows:
1, Turn the cleaner OFF and disconnect it
from the e]ectrical outlet.
2. Check dirt cup pro-filter, HEPA car-
tridge filter and secondary and final
filters for dirt accumulation.
3. Refer to "Clearing blockages" section.
4. When cleaner is unplugged and the
motor cools for 30 minutes, the ther-
mal protector automatically resets and
cleaning may continue,
If the thermal protector
continues
to
activate after following the above steps,
your cleaner may need servicing (see "Ser-
vice" section).
Service
To obtain approved HOOVER service and
genuine HOOVER parts, locate the nea
est Hoover Sales and Service Center or
Authorized Hoover Warrant3, Service Dealer
(Depot] by:
• checking the Yellow Pages under
"Vacuum Cleaners - Household" OR -
• calling !-800-944-9200 for an
automated referral of authorized
service outlet locations (U.S. only) OR -
• checking the Service section of Hoover
lnc., on-line at www.hoover.eom
Do not send your cleaner to Hoover tne. in
Glenwillow for service, this will only result
in delay.
If further assistance is needed, contact The
Hoover Consumer Response Center,
Phone: 1-800-263-6376.
In Canada, contact Hoover Canada,
Etobieoke, Ontario MdW 3R9 Phone:
1-800-263-6376,
Always identify your cleaner by the complete
model number when requesting informa-
tion or ordering parts. (The model number
appears on the bottom of the cleaner.)
16